Find y for a linear time-invariant continuous-time system

Assignment Help Electrical Engineering
Reference no: EM13275683

A linear time-invariant continuous-time system responds to the following inputs with the corresponding outputs:Ifx(t) = u(t), then y(t) = 2(1- e^-t)u(t) and if x(t) = cost,then y(t) = 1.414 cos(t - pi/4). Find y(t) for the following inputs

(a) x(t) = 2u(t) - 2u(t - 1)
(b) x(t) = 4 cos(2(t - 2))
(c) x(t) = 5u(t) + 10 cos(2t)
(d) X(t) = tu(t)

Reference no: EM13275683

Questions Cloud

Describe how the surveyor would go about : State the full name of the section of SOLAS that sets out the minimum standards for the training and competence of crew members and describe how the surveyor would go about checking that a vessel had the necessary number of qualified staff.
What are the best-case and worst-case scenarios : What are the best-case and worst-case scenarios? Calculate the sensitivity of your base-case NPV to changes in fixed costs. What is the accounting break-even level of output for this project?
Explain changes affect the value of the equilibrium constant : How do the following changes affect the value of the equilibrium constant for a gas-phase exothermic reaction:
What is the minimum uncertainty in the blocks speed : A 0.500-kg block rests on the frictionless, icy surface of a frozen pond. what is the minimum uncertainty in the block's speed
Find y for a linear time-invariant continuous-time system : A linear time-invariant continuous-time system responds to the following inputs with the corresponding outputs:Ifx(t) = u(t), then y(t) = 2(1- e^-t)u(t) and if x(t) = cost,then y(t) = 1.414 cos(t - pi/4).
What is the benefit of scenario analysis : What is the benefit of scenario analysis if it does not produce an accept or reject decision for a proposed project?
Determine the maximum emf in the alternator : In a 280-turn automobile alternator, the magnetic flux in each turn is ?B = 2.50 multiply.gif 10-4 cos ?t, where ?B is in webers, ? is the angular speed of the alternator, Determine the maximum emf in the alternator
Explain a certain hydrocarbon has a molecular formula : A certain hydrocarbon has a molecular formula of C6H10. Which of the following is not a structural possibility for this hydrocarbon?
Indicate the frequencies of the recovered modulating signal : A modulating signal consists of two sinusoidal components: 1 kHz and 3 kHz. The transmitter carrier frequency is 80 kHz. Assume in a SSB-USB modulated signal that the inserted carrier at the receiver is 200 Hz too high.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Write a verilog hdl module for the state machine

Create a state transition diagram for a simple state machine to detect a positive pulse. You choose either a Moore or Mealy machine. Write a Verilog HDL module for your state machine.

  Determine relative sizing of all the transistors to equalize

Sketch a transistor-level schematic of F=(A+BC+DE)' and determine the relative sizing of all the transistors to equalize the rise/fall time.

  Find the speed of the block after it has slid 190 m

The magnitude of the acceleration of the block is 1.93 m/s^2 (a) Find the coefficient of kinetic friction between block and plane? I got 0.393 but it is wrong. (b) Find the speed of the block after it has slid 1.90 m

  What is the unit of measure for capacitive reactance xc

The reactance in ohms of a capacitor at frequency of 500 Hz is 145 ohms; what is the value of the capacitor in uF. The reactance in ohms of a capacitor of 10 uF at a FREQUENCY of 200 Hz is

  Determine what is the frequency of oscillation

For a Wien-bridge oscillator Given R = 20Kohm and C = 10nF what is the frequency of oscillation Given a required frequency of oscillation of f = 3kHz and R = 5kohm, what should the value of C be

  How high can vce go without exceeding

A certain transistor is to be operated at a collector current of 50mA. How high can VCE go without exceeding a PD(MAX) of 1.2W?

  Calculate unit length resistance in inner n outer conductors

The cylindrical coaxial cable with the cross section shown below, has inner and outer radii of 5mm and 15mm respectively. The dielectric parameters are; er=2, signma=5*10^(-10) S/m and Ur=1

  Will the behavior of the circuit when step input is applied

Now, suppose that an initial voltage of 1V is present at the capacitor at zero time (t = 0). Will the behavior of the circuit when a step input is applied still yield an exponential rise or will the behavior be of some other type

  Calculate the power delievered to the load by each battery

Two full charged 8A-Hr batteries are connected in parallel and supply power to a resistive load of 2.4 ohms. The open-circuit voltage of both batteries is 6.4VDC and the internal(Thevenin) resistances are 0.24 ohms and 0.28ohms.

  Determine an estimate for the self and mutual inductances

The DC resistance of the primary windings of a certain transformer is found to be 22ohm while the resistance of the secondary windings is 0.8ohm. When a 60 Hz sinusoidal source is connected to the primary "with the secondary open circuited"

  At what level of significance would hypothesis be rejected

a patron of a casino doubts that the dice used in the casino are balanced. During a visit she rolles a die 100 times an got an even number only 30 times. A. formulate the hypothesis you would use to test whether the die is fair.

  What does happen when the restriction is violated

What is the function of the enable control input of a tri-state buffer. If the output of two or more tri-state buffers is connected to each other, what is the restriction on enable control input lines.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd