Find where the shell lands

Assignment Help Mechanical Engineering
Reference no: EM131382835

An artillery gun is located on a plane surface inclined at an angle β to the horizontal. The gun is aligned with the line of steepest slope of the plane. The gun fires a shell with speed u in the direction making an angle α with the (upward) line of steepest slope.

Find where the shell lands. Deduce the maximum ranges RU, RD, up and down the plane, and show that

RU/RD = (1 - sin β) / (1 + sin β).

Reference no: EM131382835

Questions Cloud

How much power is needed now : Now suppose we have a cellular system. The mobile is as described in Problem 2 but the base station has an antenna with a gain of 6 dBi located 50 m above average terrain. How much power is needed now? Is this reasonable?
Computer to a new computer : Have you ever transferred all your stored data from an old computer to a new computer? How careful did you have to be? How strenuous was the whole ordeal? Now, imagine transferring the data of an entire organization from one system to another. Or,..
Calculate the minimum repeater height : Calculate the minimum repeater height and transmitted EIRP for a repeater that must communicate with mobile stations over a 50 km radius, maintaining a minimum field strength of 50 mV/m at the mobile receiver, which has an antenna height of 1.5 m...
Which country appeals the most to you : Name at least four factors that will heavily influence your recommendation to Mr. Tobias. Explain why these factors are important. Which country appeals the most to you? Explain and defend your reasoning.
Find where the shell lands : An artillery gun is located on a plane surface inclined at an angle β to the horizontal.- Find where the shell lands. Deduce the maximum ranges RU, RD, up and down the plane.
What is the effective bandwidth for connection : Ernesto use to administered a 10 channel FDM that shared a T3. The company decided to replace the FDM with a TDM that is capable of handling 10 connections to share the T3. What is the effective bandwidth for each connection before and after the ch..
Effect of increasing power in an environment : What can you conclude from your answer about the effect of increasing power in an environment where transmission range is limited by signal-to-interference ratio?
Calculate giis weighted average cost of capital : Currently, GII's capital structure is 75% equity based and 25% debt based. GII is in 25% marginal tax bracket in France and has a cost of equity of 18% and an average debt cost of 7%. Calculate GII's weighted average cost of capital.
Declaring the instance variable : This chapter uses the class rectangleType to illustrate how to overload the operators +, *, ==, !=, >>, and

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Importance of structural mechanics in mechanical engineering

Briefly discuss the importance of Structural Mechanics in Mechanical Engineering? List four different types of loadings that can be applied on mechanical structures or components

  Describe the problem and reason for the design

Provide a dimensioned drawing of the design along with any results obtained from calculations or other analysis methods. Such as heat transfer rates, cost of materials and manufacturing, and payback period.

  1 consider the diagram below where a pump is used to draw

1 consider the diagram below where a pump is used to draw water from a lake to feed an irrigation system.a which of the

  A 1 ton car is climbing a 200 m long uphill road with a

a 1 ton car is climbing a 200 m long uphill road with a slope of 30deg from horizontal. what is the power required to

  Find speed of wind and tension in string

find speed of wind and tension in string?? (density=1. 25kg/mcube)

  High density polyethylene and low density polyethylene

Sketch the stress-strain behavior for the following pairs of polymers. Use the same axes for each pair: a) polystyrene at 0 and 60 degrees celsius b) high density polyethylene and low density polyethylene.

  A supply pallet is dropped from an airplane

A supply pallet is dropped from an airplane that is climbing at 30 degrees with an indicated air speed of 600ft/s while traveling at an altitude of 12,000 ft. Determine how long it takes for the pallet to reach the ground from it's release point.

  If the zero level of the meriam blue manometer fluid is 02

a rectangular tank open to the atmosphere is filled with water to a depth of 2.5 m as shown. a u-tube manometer is

  Volume at beginning of isothermal expansion

Two kilograms of air within a piston-cylinder assembly execute a Carnot power cycle with maximum and minimum temperatures of 750 K and 300 K, respectively. The heat transfer to the air during the isothermal expansion is 60 kJ. At the end of the is..

  Hydraulic system comprised of a reservoir and a pump

In a hydraulic system comprised of a reservoir and a pump which is 4 ft above the oil level, what would be the pressure at the outlet of the pump, if the frictional effects are neglected and the flow rate is 4 gpm

  Determine torque and power required to rotate inner cylinder

The space between two 6 in. long concentric cylinders is filled with glycerin (viscosity = 8.5X10-3 lb s/ft2). The inner cylinder has a radius of 3 in. and the gap width between the cylinders is 0.1 in. Determine the torque AND power required to rota..

  Determine the angle of twist of the end b

determine the angle of twist of the end B of the solid section relative to end C. The tubes have an outer diameter of 30 mm and an inner diameter of 20 mm. The solid section has a diameter of 40 mm.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd