Find what is the shear rate of blood at the artery wall

Assignment Help Electrical Engineering
Reference no: EM13280416

1) Blood flows through a 0.5 cm diameter artery of 50 cm length. The viscosity of blood can be assumed to be 3 cP. The mean hydrodynamic pressure drop is 17 mm Hg.
a) What is the shear stress of blood at the artery wall dyn/cm^2 ?
b) What is the shear rate of blood at the artery wall?
c) What is the volumetric flow rate of blood in cm^3/s ?

2) You are designing a hollow fiber unit. The flow-rate of blood is assumed to be at high enough a rate that blood behaves as a Newtonian fluid. The fiber diameter is 600 microns and their length is 30 cm. You want a flow-rate of 12 ml/min for each fiber. What should be the pressure drop in mm Hg across the fiber length to achieve this flow-rate? (760 mm Hg= 101,325 N/m^2).

Reference no: EM13280416

Questions Cloud

Explain the basis of the positions in the periodic table : On the basis of their positions in the periodic table, select the atom with the larger atomic radius in each of the following pairs.
What would be the yield to maturity : Fitz's 25-year bond pays 11% interest annually on a $1,000 par value. If bonds sell at $845, what is the bond's yield to maturity? What would be the yield to maturity if the bond paid interest semiannually?
What will be the net cash flow for year one of this project : The firm has a tax rate of 30 percent, an opportunity cost of capital of 12 percent, and it expects net working capital to increase by $57,000 at the beginning of the project. What will be the net cash flow for year one of this project?
Explain a compressed air car has several advantages : A compressed air car has several advantages over conventional vehicles - it has zero emissions, refueling can be done at home and there is no hazardous or rare battery chemical to deal with. The engine of such a car relies on the expansion of comp..
Find what is the shear rate of blood at the artery wall : The flow-rate of blood is assumed to be at high enough a rate that blood behaves as a Newtonian fluid. The fiber diameter is 600 microns and their length is 30 cm. You want a flow-rate of 12 ml/min for each fiber.
What is the depreciation tax shield : Assume a tax rate of 30% and a discount rate of 13%. What is the depreciation tax shield for this project in year 5?
Plot the voltage in the cap vc for all times : Let the current int he circuit be is(t) = u(t -1) and the initial voltage in the cap be Vc(0) = -1 volts. PLOT the voltage in the cap Vc(t) for all times. Suppose we double the current is(t) = 2u(t) - u(t -1) but keep same initial condition
What change in nwc occurs at the end of year 1 : The tax rate is 34 percent and the required return on the project is 11 percent. What change in NWC occurs at the end of year 1?
Explain nitrogen gas are mixed with excess hydrogen gas : For the following reaction, 5.02 grams of nitrogen gas are mixed with excess hydrogen gas. The reaction yields 4.74 grams of ammonia. nitrogen (g) + hydrogen (g) --> ammonia (g)

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the induced emf to the infinitely long wire

The 1 m long wire is oriented perpendicularly to the infinitely long wire, and the end closer to the infinitely long wire is located 0.5 m from it. Find the induced EMF. Hint: solving the problem requires integration.

  Find voltage at center node and current flowing out of leg

assuming a perfect diode, I have a small circut which has three legs joined at the center. One leg has a +12V supply and a 1K ohm resister. Second leg has a -16 Volt supply witha 2K ohm resister, and the third has a perfect diode, with a 4K ohm re..

  Determine what is the max height obtained

A ball is shot into the air at 30 degress above the horizontal. It's initial Velocity is 5m/s and lands at the same height that it is launched from. How far does it travel horizontally

  Calculate the essential bandwidth using energy percentage

a. Plot the spectra of X(w) = t sinc(wt/2). Let t = 1 and -20 =

  Calculate the equivalent series impedance of the transformer

The nameplate on a 50-MVA, 60-Hz single-phase transformer indicates that it has a voltage rating of 8.0-kV: 78-kV. An open-circuit test is conducted from the low-voltage side, and the corresponding instrument readings are 8.0kV, 62.1A, and 206kW.

  How a collection of cells can be arranged to deliver power

A single silicon photovoltaic cell is found to have an open-circuit voltage of 0.6 V and a short-circuit current of 15 mA in full sunlight. Show how a collection of these cells can be arranged to deliver 500mW at 9.0V into a load.

  Find the terminal voltage of the motor and power factor

A three phase synchronous motor has the synchronous reactance of 2.1 Ohm and draws 250 A with a lagging power factor for an excitation voltage of 1327 -15 degree per phase. Find the terminal voltage of the motor and power factor of the motor.

  Compute the complex conjugate of each of expressions

Compute the complex conjugate of each of the follwoing expressions: (a) -1; (b) -j/5

  What is the speed of the package when it hits the ground

After a package is ejected from the plane, how long will it take for it to reach sea level from the time it is ejected Assume that the package, like the plane, has an initial velocity of 200 mph in the horizontal direction.

  Write a program in c that reads 20 integers from the user

Write a program in C that reads 20 integers from the user and sums the odd numbers together and the even numbers together. The program is to output the ratio of the odd numbers to the even numbers with a precision of up to 3 decimal digits.

  How to load each number in the accumulator one at a time

There are three numbers stored in Memory Locations 10-12. Write a machine language program to load each number in the accumulator one at a time. Use the immediate addressing mode to add four to each value that is loaded to accumulator.

  Find all solutions to system using gauss elimination method

Given the following system of linear equations: x1 + 2x2 + x3 = 4, 12x1 + 16x3 = 28, 8x1 - x2 + 5x3 = 12(a) Write it in the form of Ax = b (b) Find all solutions to the system using Gauss elimination method

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd