Find what is the resulting terminal voltage on the starter

Assignment Help Electrical Engineering
Reference no: EM13265099

A car battery has an open-terminal voltage of 12 V and an internal resistance of 0.02 . If the car starter has a resistance of 0.10 in series with the batter, what is the resulting terminal voltage on the starter?

Reference no: EM13265099

Questions Cloud

Determine what is the reactance of the inductor : A perfect inductor with L = 0.2 H is connected in series to a voltage source with: v(t) = 10cos(40pi(t) 20degrees). What is the reactance of the inductor
Explain potassium dihydrogen citrate buffer standard : Calibration of a glass electrode gave a reading of 148.7 mV with 0.05 m potassium dihydrogen citrate buffer standard (pH = 3.766) and a reading of -167.4 mV with 0.01 m borax buffer standard (pH = 9.139), both measured at 30°C.
What will flashbacks eps and pe ratio : What will Flashback's EPS and PE ratio be under the two different scenarios?
Analyze the characteristics of communication protocols : Analyze and compare the characteristics of various communication protocols and how they provide application requirements.
Find what is the resulting terminal voltage on the starter : A car battery has an open-terminal voltage of 12 V and an internal resistance of 0.02 . If the car starter has a resistance of 0.10 in series with the batter, what is the resulting terminal voltage on the starter
Discussing your ruling as judge in the case : Dave claims the rings were promised to him and asks you as Judge to rule on his claim. How do you rule?
Explain the electrode follows the nernst equation : The measured potential was 0.0330 V. What is the concentration of X when the potential is 0.0480 V? Assume that the electrode follows the Nernst equation, the temperature is at 25°C, and that the activity coefficient of X is 1.
What is the return on the canadian currency : What is the local return on on the Royal Bank of Canada stock? c. What is the return on the Canadian currency, C$. d. What is the total $ return on an invest ment in the Royal Bank of Canada Stock?
Describe the operation of the series rc circuit : Describe the operation of the series RC circuit. The discussion must address phase angle relationships of current and voltage. The answer must include the effect of source frequency on the voltage drops across the resistor and the capacitor at ver..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find bandwidth using either carsons rule or universal curve

A carrier signal c(t) = 10 cos(2pifct) is modulated using a message signal m(t) cos(20pit). The modulation is FM, with kf = 50.Write equation for modulated signal What is average transmitted power & modulation index

  Compute the number of clock cycles required to execute

1- Describe the function of the program. DO NOT WRITE THE OPERATION OF EACH INSTRUCTION 2- Assuming that the branch instruction is executed (the branch is taken), comput the number of clock cycles required to execute the loop (DECA or BNE AGAIN)

  Determine the irradiance of the filament

A coiled tungsten wire of diameter 50um and length 10cm is glowing at a temperature of 2000°C within an evacuated light bulb. Determine the irradiance of the filament and the fraction of irradiance within the visible range of wavelength.

  Compute the voltage indicated

resistor: a volt-ohmmeter with an internal impedance of 1000 Ω/V and an EVM with an impedance of 11 MΩ. Calculate the voltage indicated by each of these devices.

  Explain moore sequential circuit

Moore sequential circuit, A Moore sequential circuit has one input and one output.The output goes to 1 when the input sequence 111 has occurred and the output goes to 0 if the input sequence

  Find an expression for the stored energy in capacitor

The voltage across a 1x10^(-6)F capacitor is given by v(t)=100e^(-100t) in which time t is in seconds. 1. find an expression for the current 2. find an expression for the power 3. find an expression for the stored energy

  Determine the load current i1 and the circuit current it

The power factor of a load connected to a 120-V 60-Hz source is raised from 0.866 lagging to 0.966 leading by connecting a 110.5-?F capacitor in parallel with the load. Determine the load current I1 and the circuit current IT.

  Why a long wavenenth requires a gigantic antennas

a) Why is it that if the power system of interest is physically smaller than the wavelength, we can represent it as a lumped-parameter system b) Why a long wavenenth requires a gigantic antennas

  Find the vemf when the rod is parallel with the x-axis

Suppose the z=0 plane carries a sheet current K=5. A/m x. Then a 1 m long rod exists above the current sheet and has velocity u. Find the Vemf when the rod is parallel with the x-axis, u= 2(m/s) y.

  Find how long it would take the microcontroller to execute

Given a complete sequential program without any branches (no GOTO and CALL statements) that consists of 12813 instructions and a PIC microcontroller that is connected to a 2.0 MHz external clock/oscillator

  Compare the capacities of the fiber and conducting cables

Compare the capacities of the fiber and conducting cables. How many of the conducting cables are required to equal the capacity of the fiber cable.

  What is the reactive power supplied to the sender

A 100 mile , 300kV, 60Hz transmission line has a reactance of 0.8 ohm per mile and a distributed capacitance of 200,000 ohms per mile. Draw a equivalent circuit phase at the sender end when the receiver is open. What is the reactive power supplied..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd