Find what is the pressure when the nitrogen is reduced

Assignment Help Civil Engineering
Reference no: EM13315489

One cubic metre of nitrogen at 40 degrees Celsius and 340KPa is compressed isothermally to .2(m^3). What is the pressure when the nitrogen is reduced to this volume? What is the modulus of elasticity at the beginning and end of the compression?

Reference no: EM13315489

Questions Cloud

How many tons of coarse aggregate will be required to fill : how many tons of coarse aggregate will be required to fill a trench 5 ft deep, 3 feet wide and 300 feet long. the coarse aggregate unit weight equals 93.6 lb per cu ft.
What is the induced emf in the entire solenoid : A solenoid of length 5.0 cm and diameter 0.87 cm is wound with 162 turns per cm. The current is decreasing at a rate of 38.0 A/s. What is the induced emf in the entire solenoid
Find the magnitude of the force that the car exerts on truck : A 1260 kg car pushes a 2140 kg truck that has a dead battery. When the driver steps on the accelerator, find the magnitude of the force that the car exerts on the truck?
How much would the water table need to be lowered : The specific yield of an unconfined aquifer is Sy = 0.15. How much, on average, would the water table need to be lowered (in m) in an area of 2.5 km^2 to release 6.5 x 10^5 m^3 of water from storage in this aquifer
Find what is the pressure when the nitrogen is reduced : One cubic metre of nitrogen at 40 degrees Celsius and 340KPa is compressed isothermally to .2(m^3). What is the pressure when the nitrogen is reduced to this volume. What is the modulus of elasticity at the beginning and end of the compression.
Improve decision making in environmental : Purpose and aim of strategic environmental assessment (SEA) is to improve decision making in environmental and sustainability aspects of project.
Calculate the amount of energy lost by the crate : A 50 kg crate slides down a ramp that is inclined by 30 degrees from the horizontal. Calculate the amount of energy lost by the crate due to friction in its journey down the ramp
Determine the magnitude of the reaction force exerted at b : When the engine of the plane is running, the vertical reaction that the ground exerts on the wheel at A is measured as 616lb . When the engine is turned off, however, the vertical reactions at A and B are 520lb each.
How much is the force of friction on the dresser : A Girl is pushing on a 45 kg dresser with 300 N of force. The dresser has a coeficient of statice friction of 0.83, How much is the force of friction on the dresser

Reviews

Write a Review

Civil Engineering Questions & Answers

  What was students associated perception per reaction time

An engineering student is driving on a level roadway and sees a construction sign 500 ft ahead in the middle of the roadway. the student strikes the sign at a speed of 25 mi/h.

  Determine horizontal component of reaction that pin exert

Determine the horizontal component of reaction that the pin A exerts on the two-member frame. Set F = 500 (Find Ax) Determine the vertical component of reaction that the pin A exerts on the two-member frame.

  What are the position and acceleration of body as functions

The velocity of a body is given by v(t) = 2t+t3. The body starts from rest at time t = 0 at position s(0) = (2,-10). What are the position and acceleration of the body as functions of time At what time, t, does the body cross the X-axis

  Determine the friction force exerted on the plate at a

The frame is supported in part by normal and friction forces between the wall and the plate at A. Determine the friction force exerted on the plate at A. Also determine the minimum required coefficient of friction at A for the frame to remain in e..

  Compute the maximum service concentrated live load

A 12-ft-long cantilever supports its own dead load plus an additional uniform service (unfactored) dead load of 0.5 kip/ft. The beam is made from normal-weight 4000-psi concrete and has in., in., and in.

  Determine the overall specific weight of each of the samples

Two soil samples, each having a void ratio of 0.76 and density of 2.65 grains have degrees of saturation, respectively, 85% and 100%. Determine the overall specific weight of each of the samples.

  Estimate shaft elongation in millimeters with applied force

A 4.00-cm-diameter, 0.80-m long rod of aluminum 7075-T6 is subjected to an axial tensile force with a factor of safety of 1.75. The yield stress and modulus of elasticity of aluminum 7075-T6 are 500. MPa and 210. GPa, respectively.

  Find what is the annual crash rate for the intersection

The four approach volumes per day at this intersection are 28,648, 23,856, 12,150, and 10,174. The crash totals for the last 3 years are 91, 96, and 87. What is the annual crash rate for this intersection

  Percent by weight of limestone

A slurry containing 20 percent by weight of limestone (CaCO 3 ) is processes to separate pure dry limestone from water. If feed rate is 2000kg/h, how much CaCO 3 is produced per hour?

  Calculate the escalaed dollar irr for an escalated dollar

an investment of $80,000 is projected to generate escalated dollar net revenues (income minus costs) of $10,000 in year one, $30,000 in year 2 and $40,000 in year 3 with a $100,000 salvage value at the end of year

  What length x must the seaward arm of the breakwater

Consider an L-shaped breakwater that protects a small harbor dredged to a uniform depth of 6 m. For a 2 m high, 10 s period incident wave at the head of the breakwater having incident wave direction of 60 degrees

  Determine the maximum stress and strain in the ball

A rubber ball is inflated to a pressure of 65 kPa .At that pressure the diameter of the ball is 240mm and the wall thickness is 1.25 mm.The rubber has a modulus of elasticity E of 3.6 Mpa and a poisoon'd ratio of 0.48.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd