Find what is the pressure on the soil if theta is 45 degrees

Reference no: EM13305236

A pipe is to be installed under the ground on a bed of aggregate 6 in. thick. The entire weight on the aggregate from pipe and soil above the pipe is 1800 lbs. per linear foot of pipe. What is the pressure on the soil if theta is 45 degrees? Assume the pipe load on the aggregate acts on a line.

Reference no: EM13305236

Questions Cloud

What is the value of the energy stored in the inductor : Consider the following circuit with emf = 12 V, C = 2 microF, L = 6 microH, and R = 6ohms. What is the value of the energy stored in the inductor

Find the length of the studs in a rake wall with base height : Find the length of the studs in a rake wall with a 5:12 pitch, a half span of 9'4", 16" OC and a base height of 7'3".

Calculate the separation of the two slits : Young's experiment is performed with light of wavelength 502nm from excited helium atoms. What is the separation of the two slits

Find what depth of aggregate is needed at the angle theta : A 2000-lb wheel load is to be supported by aggregate over soil with a maximum bearing pressure of 1000 lb/sqft. What depth of aggregate is needed if the angle theta is 40 degrees

Find what is the pressure on the soil if theta is 45 degrees : A pipe is to be installed under the ground on a bed of aggregate 6 in. thick. The entire weight on the aggregate from pipe and soil above the pipe is 1800 lbs. per linear foot of pipe. What is the pressure on the soil if theta is 45 degrees

Compute the wavelength of the light that falls on the slits : Coherent light from a sodium-vapor lamp is passed through a filter that blocks everything except for light of a single wavelength. compute the wavelength of the light that falls on the slits

Calculate the compacted cubic yards per hour over 10-inch : Calculate the compacted cubic yards per hour if a compactor with a 5-ft drum width travels at 3 mph over a 10-in. lift of aggregate base course with 4 passes required to meet density specifications under average operating conditions.

Obtain the self-induced emf in the solenoid : A 0.10 m long solenoid has a radius of 0.05 m and 15000 turns. The current in the solenoid changes at a rate of 6.0 A/s. Determine the self-induced emf in the solenoid

Why its necessary to require conditions-sand cement ratio : Why is it necessary to require such conditions-sand cement ratio, w/c ratio and type of sand. A graded sand is specified for use in the mortar cube test. What would be the likely results if a one-sized sand was used instead of a graded sand.

User Account

All Pages