Find void ratio and wet unit weight for degree of saturation

Assignment Help Civil Engineering
Reference no: EM13296601

A sand sample has a porosity of 38% and specific gravity of solids of 2.66. Find the void ratio and wet unit weight in lb / ft3 if the degree of saturation is 35%.

Reference no: EM13296601

Questions Cloud

How much work is done by the persons weigh : A rescue helicopter lifts a 85 kg person straight up by means of a cable. The person has an upward acceleration of 0.70 m/s2, How much work is done by the person's weight
Determine the change in specific enthalpy of the argon : Argon gas is heated in a constant pressure process from 20.0 to 500.°C. Assuming ideal gas behavior, determine: a. The ratio of the final to initial volumes. b. The change in specific internal energy. c. The change in specific enthalpy of the argon.
Our body contains four different membranes : Our body contains four different membranes (physical barriers), each with a specific function. Understanding their different roles and functions, please describe what you think would happen to the body if each was damaged?
Define what is the empirical formula of the organic compound : A carbon-hydrogen compound is burned in an excess of oxygen to give 1.76g of carbon dioxide and 0.900g of water as the products of combustion. What is the empirical formula of the organic compound
Find void ratio and wet unit weight for degree of saturation : A sand sample has a porosity of 38% and specific gravity of solids of 2.66. Find the void ratio and wet unit weight in lb / ft3 if the degree of saturation is 35%.
Is the company inventory policy optimal : Clap Off manufacturing uses 1,300 switch assemblies per week and then records another 1,300. If the relevant carrying costs per switch assembly is $5 and the fixed order cost is $575, is the company's inventory policy optimal? Why or Why not?
Find the coeffiant of kinetic friction in vertical direction : a 60.0 n force is applied at an angle of 35 degrees to a 7.00 kg block pressed against a rough vertical wall, What is the coeffiant of kinetic friction in the vertical direction
Explain nacl in the solvents bf3 and h2o and ch3(ch2)2oh : Correct orders the solubility, from greatest to least, of NaCl in the solvents BF3, H2O, and CH3(CH2)2OH
Determine the peak emf of this generator : The coil of a generator has a radius of 0.16 m. When this coil is unwound, the wire from which it is made has a length of 5.8 m. What is the peak emf of this generator

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the couple m required to hold the system

the pin at B is attached to member ABC and can slide freely along the slot cut in the fixed plate. Neglecting the effect of friction, determine the couple M required to hold the system in equilibrium when.

  Determining maximum acceleration and maximum velocity

The posItIon of a particle along a straight line is given by s = (t 3 - 9t 2 + 1St) ft, where t is in seconds. Determine its maximum acceleration and maximum velocity during the time interval 0 :5: t :5: 10 s.

  Design a cantilever

Need to design a cantilever retaining wall 8m high, saturated unit weight is 16kn/m 3 , surcharge is 7kn/m 2 , load above wall supported on wall stem

  Concentration of tracer in the reactor

What is the concentration of tracer in the reactor 1 h after tracer addition is terminated? The reactor had an initial concentration of tracer of 1.0 mg/L when tracer addition commenced.

  Probability of finding a bad rivet

Samples of 20 rivets for a steel structure are checked for quality every hour. The probability of finding a bad rivet that has to be scrapped is 1%.assume that x is the number of parts in the sample of 20 that have to be scrapped.

  Define concentration of pollutant in the effluent leaving

A lagoon with volume 1200 m^3 has been receiving a steady flow of a conservative waste at a rate of 100m^3/day for a long enough time to assume that steady-state conditions apply

  Rankine cycle and thermal efficiency

Determine the rate at which heat is added in the boiler, the power required to operate the pumps, the net power produced by the cycle, and the thermal efficiency.

  Find the rate of change in volume

A water tank has a height of 120m, and its area of cross-section is 2000m. Water is released from the tank and the water level drops by 1 meter every minute. Find the rate of change in volume.

  Calculate the maximum rod diameter

If the tensil testing machine can apply no more than 925 lbs. of force to the specimen, calculate the maximum rod diameter that should be used. (precision 0.000)?

  What are the surface overflow rate

a rectangular clarifier with a length:width ratio of 3:1 receives a flow of 850m3/day. the clarifiers depth is 4.0m and the detention time of the water inthe clarifier is 2.4 hrs, what are the surface overflow rate and the horizontal flow through ..

  Coefficient of friction-skidding resistance

Two passenger cars are traveling at 65 MPH on a highway moving in the same direction in the same lane. The cars are separated by 25 feet for every 10 MPH of their speed. The coefficient of friction (skidding resistance) between the tires and the r..

  Calculate the ozone column amount in du

Calculate the ozone column amount in DU, corresponding to the pressure profile and ozone concentrations given above. Recall Avogadro's number, NA = 6.0 × 1023 molecules per mole, from which one can calculate [O3]= ..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd