Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
Suppose you have a line charge and a point charge in space. A point charge of 16nC is located at Q(2,3,5) in free space, and a unifor line charge of 5nC/m is at the intersection of the planes x=2 and y=4. If the potential at the origin is 100V, find V at P(4,1,2).
The magnetic tape recorder uses linear analog to digital encoding. Telephone systems use non linear analog to digital conversion. Explain the difference.
A circular loop TV antenna with 0.01 m2 area is in the presence of a uniform -amplitude 300 MHz signal. When oriented for maximum response, the loop develops an emf with a peak value of 20 mV. What is the peak magnitude of B of the incident wave?
Using coppers resistivity of 10.30 CM-olm/ft at +25 °C, find how long a 1 inch square bar of copper would need be to have a resistance of 1 at +20 °C
Calculate the value of vL developed across a 300 H coil when the instantaneous rate of change in component current equals 500 mA/s.
Electrical & Instrumentation Use, State typical values for the loading effect on a low voltage AC circuit containing a lamp when measuring current with
A calibrated RTD with ALPHA = 0.0041/°C, R = 306.5 Ohms at 20°C, and PD = 30 mW/°C will be used to measure a critical reaction temperature. Temperature must be measured between 50° and 100°C with a resolution of at least 0.1°C.
Determine the response of the system when aunit step is applied at input.
Write a brief explanation of the principles of the super-heterodyne receiver. It may help to use a simple block diagram to express the process. Explain the purpose of the Intermediate Frequency amplifiers,
Compute and plot the correlation sequences r s1s2 (l), r s0s0 (l), r s1s0 (l) and r s2s0 (l) . Compute and plot the cross-correlation sequences and of the received signal with the template signals and s 2 (n).
A manufacturer specification sheet lists the transfer function of a pressure sensor as 45±5% mV/kPa with a time constant of 4±10%. A highly accurate test system applies a step change of pressure from 20 kPa to 100 kPa.
the circuit has been connected for several seconds, find current in (a). in the 4.00 volts battery, (b). in the 3.00 ohm resistor, (c). in the 8.00 volts battery, (d). in the 3.00 volts battery and (e). find the charge on the capacitor?
the worker's safety harness D-ring is attached to a 12-foot shock absorbing lanyard that is securely fastened to the structure at a point 40 feet above ground level. Does this arrangement violate OSHA standards for fall protection? Explain.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd