Find two designs using open-circuited stubs

Assignment Help Electrical Engineering
Reference no: EM13226695

A load impedance ZL = 100 + j80 is to be matched to a 75 ohm line using a single shunt-stub tuner.
Find two designs using open-circuited stubs.

Include both smith chart and analytical analysis.

Reference no: EM13226695

Questions Cloud

What is the instruction to initialize the sp register : With regard to assembly language and the HCS12: What is the instruction to initialize the SP register Why do we initialize that register What is the reason we initialize it with the value $4000 for this microcontroller
Explain what is the rate of formation n2o5 : For the following reaction if the rate of disappearance of O2 is 0.0450 mol L-1s-1, what is the rate of formation N2O5(g)?
Design a single-stage 3-input compound cmos minority gate : A majority gate returns a true output if more than half of the inputs are true. So, a 3-input majority gate outputs a ‘1' if at least two of its inputs are ‘1'. A minority gate generates the complement, that is it outputs ‘0' if at least two of th..
Explain product xyz necessarily vanish when integrated over : Does the product xyz necessarily vanish when integrated over a a) cube, b) tetrahedron, c) hexagonal prism, each centered on origin?
Find two designs using open-circuited stubs : A load impedance ZL = 100 + j80 is to be matched to a 75 ohm line using a single shunt-stub tuner. Find two designs using open-circuited stubs. Include both smith chart and analytical analysis.
Explain what is the value of kp for the reaction : For the system CaO(s) + CO2(g) = CaCO3(s), I added 1.00 mol of CaO(s) to 1.00L of 0.500M CO2(g) at 200 oC. At equilibrium the [CO2] = 0.150M. What is the value of Kp for this reaction?
What are the predominant beliefs and values : What are the predominant beliefs and values in the United States that have driven the development of health care system. How have these beliefs and values played a part in the U.S. opposition to health care reform?
Find out the heat of combustion of sucrose : A 250 g sample of sucrose C12H22O11(s) was burned in a 21.00 kg iron calorimeter immersed in 1.450 Kg of water. The initial temperature of the system was 24.32 degrees Celsius. Determine the heat of combustion of sucrose under the conditions prese..
Is this delegation of power too broad or too restrictive : Are all laws ethical? Why or why not? Provide examples of ethical and unethical laws and a statute gives the Department of the Interior the power to allow or curtail mining in the national forests "as the best interests of all users of the national..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Define differences in the theoretical and measured values

Include worked solution, a discussion of any differences in the theoretical and measured values and screenshots that show your measurements and paste them into a document

  What is the time-bandwidth product in the case

A radar transmits a monotone pulse of 5-s duration. Suppose the radar were redesigned so that the same pulse envelope is frequency modulated with linear FM over 100 MHz. (a) What is the possible new range resolution

  How much coal did we burn

The residential sector of PA consumed about 150.6x1012 Btu of electricity (www.eia.doe.gov). Assuming all of this energy comes from bituminous coal with a heating value of 14,000 Btu/lb. How MUCH coal did we burn?

  Determine the maximum torque occurs at starting

A three phase, 25-hp, 440-V, 60-Hz, 1750 rpm, wound-rotor induction motor has the following equivalent circuit parameters: R1=0.20 ohms, X1=1.0 ohms, R2=0.15 ohms, X2=0.8 ohms, Xm=30 ohms. The motor is connected to a three phase, 440-V, 60-Hz supply.

  Describe the components and variables of biological control

a) Describe the components and variables of the biological control apparatus involved in walking toward an object that can be seen on the horizon b) Why is walking a closed-loop operation

  Explain half-wave rectifier

Half-Wave Rectifier, For the half-wave rectifier, the source is a sinusoid of 120 Vrms at a frequency of 60 Hz. The load resistor is 5 ohms. Determine

  What approximate minimum ber is required for voice signals

What approximate minimum BER is required for voice signals, data signals and what is the approximate BER level for the optical fiber systems ?

  Find the applied voltage of an iron-core transformer

Find the applied voltage of an iron-core transformer if the secondary voltage is 240 v, and Np = 60 with Ns = 720

  Find nd on n side

Built-in voltage for a Si p-n junction is tested to be 0.6 V, NA = 2 X 10^15 cm^-3 on p side. Find ND on n side. (Assume ni = 1 x 10^10 cm^-3; and k*T/q= 0.026 V)

  Explain briefly the digital output values

Explain briefly from what you notice about the digital output values in (a) why a digital output value of an A/D converter is rarely the exact same digital value as the analogue input value.

  Determine the corediameter required for the fiber topermit

determine the corediameter required for the fiber topermit its operation over the wavelength range 1.48 to 1.60um. calculate the new fiber core diameter to enable single mode transmission at a wave length of 1.30um.

  Draw the gate-level diagram

Write the logic equation for Y in terms of A,B,C that solves this problem, and draw the gate-level diagram.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd