Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1.A turbine located 225 m below the water surface at intake, carries a flow of 3.5 m^3/s. The head loss in the pipeline leading to it is 10 m. Find the power (kW) delivered by the turbine if its efficiency is 92%.
2.Head loss and sunshine striking a pipeline cause the temperature of the water flowing inside to rise by 2 degrees Celsius between two measuring points. Find the heat gain in J/N and cal/N.
3.Water at 60 degrees Fahreneit flows at 3 cfs through a 150-ft-long duct of 6 in X 9 in cross section. The pressure at the inlet end is 15 psig, and at the outlet, 20 ft higher than the inlet, it is 4 psig. Find the wall friction head loss, and the friction force on the duct. Neglect energy losses caused by bends.
After compaction the void ratio is reduced to 0.60. Determine: (a) Dry and moist unit weights before and after compaction (b) Degree of saturation after compaction.
When analyzing a truss using the method of sections to find theforces in specific members. What is a good strategy to helpdecide where to make the cuts to separate the truss into separatesections?
how far back from the front axle would the center of gravity have to be to ensure that the maximum tractive effort developed for front- and rear- wheel-drive options is equal (assume that all other variables are unchanged)
Determine the required mass of block A so that when it is released from rest it moves the 5-kg block B a distance of .75m up along the smooth inclined plane in t=2s. Neglect the mass of the pulleys and cords.
Determine the vertical deflection in inches at the midpoint, called point F, between points B and C. Use E=29,000 Ksi, I=800 inches^4, and A=6.0 inches^2 for all members. Use the Virtual Work Method.
A trapezoidal canal 6m wide at the bottom and having a side slope of 1V:2H carries water with a mean velocity of 1.0m/s to a depth of 60cm. What length of contracted rectangular weir 1.0m high should be placed at the middle of the canal to make th..
Water flows steadily through a horizontal nozzle. The nozzle inlet diameter is 6 in. At the nozzle outlet, where the pressure is atmospheric, the diameter is 2 in. Determine the pressure head at the nozzle inlet to produce a water jet velocity of ..
Find the absolute value of the magnitude of force vector B if the resultant force= 1000 lb, force vector A= 1000 lb, and the resultant forms a 45 degree angle with B, and vector B runs parallel to the y axis.
The shape below has a cut along the entire length of the member thus making it an open section. The uniform thickness is 0.125in. Determine the maximum shear stress for the shape. Compare the stress for this open shape to a shape without a cut.
The water line to a house is usually 3'4" copper tube. Find the flow rate that can be delivered and still maintain laminar flow in the tube
determine the total dead load, per foot of length, each beam must support.
A company has been discharging its waste into a holding pit for a long time. For the last several years, the pit has been full and overflowing into a local river. The waste concentration has been nearly constant at 10 mg/L of the pollutant of inte..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd