Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
an amplifier operating from + - 3V supplies provides a 2.2-V peak sine wave across a 100 ohm load when provided with a 0.2-V peak input from which 1.0 mA peak is drawn. The average current in each supply is measured to be 20 mA. Find the voltage gain, current gain, and power gain expressed as ratios and in decibels as well as the supply power, amplifier dissipation, and amplifier efficiency.
A voltage divider is required to produce a 5.5 v output from a 12 v source. If one of the resistor values is 1.0 k, what value is required for the second resistor so that the voltage across the 1.0k resistor is 5.5v
Write a control algoirthm for a temperature control loop for a heat echanger (steam to hot water) employing a temperature control valve, controller, and thermostat. In your algorithm include a step change and ramp change.
The line is terminated in a load RL = 25 ohm. Use the bounce diagram to plot V(t) at a point midway along the length of the line from t = 0 to t = 25 ns.
A 200hz(mode 1), 50% duty cycle square wave is to be generated at Timer0 interrupt. a) write a main program that would set Timer0 and the interrupt,and then force the first interrupt.
when an AC source is connected accross a 12.0 resistor,the rms current in the resistor is 8.00 A find (a) the rms voltage accross the resistor,(b) the peak voltage of the source , (c) the maximum current in the resistor
(1) What might be an example of an input and an output What are some simple examples of what constitutes the distinction between input into a program and output from the program (2) What type of arithmetic operations are supported in C++
Two resistances R1 and R2 are connected in series. We know that R1=60 ohms and that the voltage across R2 is three times the value of the voltage across R1. Determine the value of R2.
A meter stick is found to balance at the 49.7-cm mark when placed on a fulcrum. When a 60.0-gram mass is attached at the 27.0-cm mark, the fulcrum must be moved to the 39.2-cm mark for balance.
what size capacitor should be placed in series with the series combination of 800 ohms and 20mH to give an admittance whose magnitude is 1m/ohm at w=10k rads/s
A 10kVA, 200/400V 50Hz single-phase transformer gave the following test results. O/C test: 200V, 1.3A, 120W, on l.v. side. S/C test: 22V, 30A, 200W on h.v. side. (a) Calculate the magnetizing current and the component corresponding to core loss at ..
design and implement an access control circuit for my research lab. There are two inputs - a key card swipe on the door that produces an ID in the 0.7 range, and a day/night sensor that is 1 during the day, and 0 at night.
A painter is standing on a work platform that is 27 feet above ground level. For fall protection, the worker''s safety harness D-ring is attached to a 12-foot shock absorbing lanyard that is securely fastened to the structure at a point 40 feet above..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd