Find the vemf when the rod is parallel with the x-axis

Assignment Help Electrical Engineering
Reference no: EM13247113

Suppose the z=0 plane carries a sheet current K=5. A/m x. Then a 1 m long rod exists above the current sheet and has velocity u. Find the Vemf when the rod is parallel with the x-axis, u= 2(m/s) y.

Reference no: EM13247113

Questions Cloud

Determine vemf and draw the polarity with a sketch : the z-axis carries a 10mA current in the +z direction. A second line of current parallel to the first is located at x= 0, y=3cm carrying a 10 mA current in the -z direction. A rod exists in the y-z-plave from y= 1cm to y= 2 cm. velocity u = 2m/s z..
Explain iron oxide reacts with carbon to give iron : Iron(III) oxide reacts with carbon to give iron and carbon monoxide; Fe2O3(s)+3C(s)-->2Fe(s)+3CO(g). a) How many grams of C are required to react with 2.50 mol of Fe2O3
Find out how to use the solve function to solve for va : To analyze electric circuits, it is often necessary to solve simultaneous equations. To find the voltages Va, Vb, and Vc at nodes a, b, and c, the equations are 2(Va-Vb) + 5(Va-Vc) - e^(-t) =0 2(Vb-Vc) + 2Vb + 3(Vb-Vc) =0
Find the expected overall pulse height resolution : If this system is used with a detector with an intrinsic pulse height resolution of 4%, what will be the expected overall pulse height resolution
Find the vemf when the rod is parallel with the x-axis : Suppose the z=0 plane carries a sheet current K=5. A/m x. Then a 1 m long rod exists above the current sheet and has velocity u. Find the Vemf when the rod is parallel with the x-axis, u= 2(m/s) y.
Find the impulse delivered to the ball by the racket : A tennis player receives a shot with the ball ( 0.0600kg) traveling horizontally at 50.0 m/s, what is the impulse delivered to the ball by the racket
Explain nitrogen gas reacts with hydrogen gas : Nitrogen gas reacts with hydrogen gas to produce ammonia by the following equation, N2(g)+3H2(g)-->2NH3(g). a) If you have 1.80 mol of H2, how many grams of NH3 can be produced
Explain ammonia is mixed with oxygen : A 2.00 g sample of ammonia is mixed with 4.00 g of oxygen. Which is the limiting reactant and how much excess reactant remains after the reaction has stopped
Determine the center of the rectangle : The drawing shows six point charges arranged in a rectangle. The value of q is 9.0 uC, and the distance d is 0.13 m. Find the total electric potential at location P

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the required forward-bias diode voltage

The forward-bias current in a GaAs pn-junction at T = 300 K is ID = 15 mA. The reverse-saturation current is IS = 10^-19 A. Determine the required forward-bias diode voltage.

  What is maximum permissible strength of electric field

how does your answer change if the bubble is elongated in the direction of the electric field and sphere and the dielectric shell are placed in an initially uniform electric field E 0 in the z direction.

  Amplify the signal of a microphone with internal resiatance

What value of emitter resistor would you choose, if: a) You have to amplify the signal of a microphone that has an internal resistance of 100K using a Common Emitter bias configuration b) you have to drive a load of 50 with an Emitter Follower cir..

  What is the permeability of the relays magnetic circuit

The springs effect is addressed below. As a relay some contacts are connected to, and move with, the armature. Other contacts are stationary and would make or break contacts as the armature moves.

  Calculate the motors starting current

A 1000V, 50 hp compound motor runs at a speed of 750 rpm at full load. The armature, series and shunt field resistances are 0.5 ohm, 1 ohm, and 200 ohm, respectively. The motor efficiency at this condition is 80%. Calculate the motors starting cur..

  Design the interface between computer output port and relay

An alarm is powered by 120 VAC, and the on/off state of the alarm is controlled by an EM relay. Design the interface between a computer output port and the EM relay. The dropout voltage is 3.5 V, and the coil current needs

  Explain finding rms current through capacitor and inductor

Finding rms current through Capacitor and Inductor, A circuit consists of a sine wave signal generator and a reactive component (L or C). The output of the generator is a sine wave with a peak amplitude of 8.8 volts at a frequency of 10.0 kHz.

  Find the electric field intensity using spherical vectors

(a) Find the electric field intensity using Cartesian vectors, Ecart, at the free space point P(-2.00 m, 5.00 m, 2.00 m). (b) Find P in spherical coordinates. (c) Find the electric field intensity using spherical vectors, Espher.

  How high can vce go without exceeding

A certain transistor is to be operated at a collector current of 50mA. How high can VCE go without exceeding a PD(MAX) of 1.2W?

  Find the volume of a frustum of a pyramid with square base

1. Find the volume of a frustum of a pyramid with square base of side 17, square top of side 9 and height 14.2. The base of a solid is a circular disk with radius3. Parallel cross sections perpendicular to the base are squares.

  What is percent quantization error if 1volt max signal input

A unipolar 16 bit ADC measures 0-10 volts full scale. a) What is the minimum resolvable voltage b) What is the percent quantization error c) What is the percent quantization error if a 1 volt max signal is input

  Define a three-phase overhead transmission line

A three-phase overhead transmission line has a per-phase resistance of 0.15 ohm/km, and a per-phase inductance of 1.3263 mH/km.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd