Find the velocity of the car atthe bottom of the hill

Assignment Help Physics
Reference no: EM13565424

The brake is released on a car of mass 500 kg at the top of ahill with height 150m.

(a) If there is no friction, find the velocity of the car atthe bottom of the hill.

(b) The car is observed to have a velocity 50m/s at the bottomof the hill. Calculate the work done by the frictional forces.

Reference no: EM13565424

Questions Cloud

Evaluate the inductance of the coil : The inductance of a closely wound coil is such that an emf of3.0 mV is induced when the current changes at the rate of4.6 A/s. Calculate the inductance of the coil
Find the average power dissipated in the resistor : A resistor with R = 2.2kΩ is connected to an AC generator that operates at 60 Hzwith an amplitude of 34 V. Find the amplitude of the current through the resistor. Find the average power dissipated in the resistor.
Evaluate the volume of a sample of carbon monoxide : Calculate the volume of a sample of carbon monoxide at -20.°C and 328 torr if it occupies 3.65 L at 298 K and 725 torr. A sample of chlorine gas is confined in a 7.5 L container at 220. torr and 27°C. How many moles of gas are present in the sample
Usual chain of commands through the administration : Higher ed executives often employ faculty in problem solving and decision making instead of using usual chain of commands through the administration. Why do you think this happens?
Find the velocity of the car atthe bottom of the hill : The brake is released on a car of mass 500 kg at the top of ahill with height 150m. find the velocity of the car atthe bottom of the hill
Detective fiction gothic fiction postmodern fiction : Which of the below was not a popular genre during the Victorian era? detective fiction gothic fiction postmodern fiction
Find the location of the center of mass of a nonuniform rod : Find the location of the center of mass of a nonuniform rod0.38 m in length if its density varieslinearly from 0.92 g/cm at one end to5.30 g/cm at the other end. Specify thecenter-of-mass location relative to the less-massive end of therod.
What is the final kinetic energy of the rifle : A marksman holds a rifle of mass MR=3.00kg loosely inhis hands, so as to let it recoil freely when fired. He fires abullet of mass MB=5.00g horizontally with a velocityrelative to the ground of VBX = 300 m/s. What is the recoil velocity of the rifle?
What is themagnitude of the minimum normal force : The contains 410 turns and has an area per turn of 3.1 x10-3 m2. The magnetic field is 0.23 T, andthe current in the coil is 0.26 A. What is themagnitude of the minimum normal force

Reviews

Write a Review

Physics Questions & Answers

  Evaluate the temperature of the hot filament

A certain lightbulb has a tungsten filament with a resistance of 20.5 ? when at 20.0°C and 136 ? when hot. Find the temperature of the hot filament

  Find the induced current in the resistor

Find the induced current I in the resistor. A rolling axle, 1.30 m long, is pushed along horizontal rails at a constant speed v=2.91 m/s. A resistor R=0.475Ω is connected to the rails at points a and b, directly opposite from each other.

  Estimate the light intensity reaching the photo cell

Suppose unpolarized light of intensity 150 W/m^2 falls on the polarizer at an angle 30. What is the light intensity reaching the photo cell

  What is the magnitude of the total magnetic force

A current of 0.14 A is maintainedin a rectangular loop of wire lying flat on a table top. what is the magnitude of the total magnetic force on the wire loop

  What is the tensile stress in the wire

A force of 83 Newtons is applied to a wire with a diameter of 0.5 mm. What is the tensile stress (in N/m2) in the wire

  Find the kinetic energies of rod

Two thin rods of length L are rotating with the same angular speed ? (in rad/s) about axes that pass perpendicularly through one end. Find the kinetic energies of rod A with its attached particle and of rod B

  What was the bullets speed as it left the barrel

A rifle is aimed at a target that is 55m away. The bullethits the target 1.5cm below the aim point. What was the bullet's flight time? What was the bullets speed as it left the barrel?

  What mass would you need to attatch to the spring

A spring with an elastic constant of 26 N/m, and want it to oscillate once every 0.75 seconds. What mass would you need to attatch to the spring

  What is the surface area of the plates

The spacing between the plates of a 1.0x10^-6F capacitor is 0.05mm. what is the surface area of the plates

  At what positive time does the particle pass through origin

The position function x(t) of a particle moving along an x axis is x = 4.0 - 4.5t2, At what positive time does the particle pass through the origin

  How fast is he propelled in the opposite direction

A 40 kg skateboarder (Ms) on a 3 kg board (Mb) is training with two 5 kg weights (Mw). How fast is he propelled in the opposite direction after the weights are thrown

  Determine the charge on theplates before and after immersion

A parallel-plate capacitor in air has a plate separation of 1.50 cmand a plate area of 25.0cm2. The plates arecharged to a potential difference of 2.50 x 102 V anddisconnected from the source. The capacitor is then immersedin distilled water.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd