Find the value of r and x of the circuit

Assignment Help Electrical Engineering
Reference no: EM13258537

A coil with impedence 8+j6Ω is connected in series with a capacitive reactance X. The series combination is connected in parallel with a resistor R. given that the equivalent impedence of the resulting circuit is 5/_0'Ω, find the value of R and X.

Reference no: EM13258537

Questions Cloud

How much will you be willing to lend to your brother : Your brother has asked you for a loan and has promised to pay back $7,750 at the end of three years. If you normally invest to earn 6 percent per year, how much will you be willing to lend to your brother?
How does the resolving power : How does the resolving power of the 5-m telescope compare with that of the Hubble Space Telescope? Why does the HST outperform the 5-m telescope.
How much will she have at the end of four years : Your aunt is planning to invest in a bank CD that will pay 7.5 percent interest semiannually. If she has $5,000 to invest, how much will she have at the end of four years?
What do you think the impact is to the image management : After the occurrence of Hurricane Katrina, insurance companies refused to pay claims to insurance holders who paid premiums on time and had binding legal contracts.
Find the value of r and x of the circuit : A coil with impedence 8+j6Ω is connected in series with a capacitive reactance X. The series combination is connected in parallel with a resistor R. given that the equivalent impedence of the resulting circuit is 5/_0'Ω, find the value of R and X.
What is the cost of goods sold : A firm has beginning inventory of 300 units at a cost of $11 each. Production during the period was 650 units at $12 each. If sales were 700 units, what is the cost of goods sold (assume LIFO)?
Explain the normal boiling point for h2se is higher : The normal boiling point for H2Se is higher than the normal boiling point for H2S . This can be explained by
Prepare flexible budget : Prepare flexible budget for ABC Manufacturer on production of10,000, 15,000, and 20,000 units
What is the value of ending inventory : There was no inventoryat the beginning of the year. What is the value of ending inventory, assuming the use of direct costing?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Describe steps in procedure based on grid-based color

describe the steps in the procedure based on grid-based color/texture histogram similarity measure for database retrieval of images that closely match a query image.

  What is the average current if the duty cycle is given

An H-bridge allows a 4 A current pulse to the drive motor. What is the average current if the duty cycle is 75% and the pulse frequency is 2 kHz

  Determine the majority and minority carrier concentrations

A junction employs Nd = 8x 10^17cm^-3 and Na= 2 x 10^ 17 cm^-3. The device is at 300K. (a) determine the majority and minority carrier concentrations on both sides (b) Calculate the built-in potential at (i)T=250K (ii)300K

  Determine the requirements of the digital fiters

Determine the requirements of the digital fiters needed and design and write the di erence equations for the digital fiters.

  Determine the noise on the output as percent fs

A system is needed to measure flow, which continuously cycles between 20 and 30 gal/min with a period of 30 sec. The required output is a voltage varying from -2.5 to +2.5 V for the cycling flow range. The sensor to be used has a transfer function..

  Find two designs using open-circuited stubs

A load impedance ZL = 100 + j80 is to be matched to a 75 ohm line using a single shunt-stub tuner. Find two designs using open-circuited stubs. Include both smith chart and analytical analysis.

  Find minority carrier concentration at emitter-base junction

A Si p-n-p transistor has impurity concentrations of 5´1018, 2´1017, and 1016 cm-3 in the emitter, base, and collector, respectively. The base width is 1.0mm, and the device cross-sectional area is 0.2 mm2.

  What is steady state response of system due to an input

assuming k>0 what is steady state the response of the above system due to an input of the form , x(t) = 2sigma(t)+u(t). where sigma(t) denotes unit impulse function and u(t) denotes unit step function

  Evaluate cross or auto correlation

You have to figure out which one using cross or auto correlation.

  Calculate the area required for a photovoltaic array

under insolation conditions 500 W/m^2 (direct sunlight), and 10% solar cell efficiency, calculate the area required for a photovoltaic array capable of running an electric vehicle driven by a single 40 hp motor for 3 hours at half power

  Find real part of the network is a series rlc

Consider a network with a driving-impedance Z. (1) Find expression for P and Q. (2) Find p(t) in terms of P and Q. (3) Suppose that the network is a series RLC. Interpret the result in part (2).

  Find the depletion width nd its extent in each of the region

The acceptor concentration in a particular junction is 10^6/cm^3 and the donor concentration is 10^15/cm^3. Assume ni=1.5*10^10/cm^3. Find the junction built-in voltage.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd