Find the transfer function of a second-order system

Assignment Help Electrical Engineering
Reference no: EM13255616

Find the transfer function of a second-order system that yields a 10% overshoot and a settling time (Ts) of 1.5s, plus tell the nature of the system?

Reference no: EM13255616

Questions Cloud

A distilled water and measuring it with a spectrofluorometer : When filling a cuvette with distilled water and measuring it with a spectrofluorometer, upon excitation at 350nm, a band around 397nm appears. This is either a fluorescence band or a Raman band. Suggest what you can do experimentally to identify w..
Explain can the op amp have a gain less than one : Discuss different applications that could use non-inverting and inverting amplifier circuits. Will the actual op Amp characteristics cause any challenges it used for each application.
What are the portfolio weights : Considering the effects of diversification, how should Sarah respond to the suggestion that you invest 100 percent of your 401(k) account in East Coast Yachts stock?
Explain what volume of gas is produced at stp : A 500 mg tablet of antacid (all 500mg is calcium carbonate) is put into 250 ml of 0.12M hydrochloric acid. What volume of gas is produced at STP and how many moles of excess H3O+ are left over
Find the transfer function of a second-order system : Find the transfer function of a second-order system that yields a 10% overshoot and a settling time (Ts) of 1.5s, plus tell the nature of the system
Explain what is the volumetric flow rate of product gas : If the propane and air streams enter the chamber at 25.0°C and 1.20 atm (absolute), and the products leave the chamber at 290.0°C and 2.90 atm (absolute), what is the volumetric flow rate of product gas from the chamber
Determine the rotational power loss in hp : A shunt dc motor has RA = 0.1-ohm and VT = 440 V. For an output power of 16.1 hp, nm = 1,213 rpm and IA = 103 A. The field current remains constant. Find the the rotational power loss in hp.
Compare the on-state and off-state losses : A new type of Schottky diode is optimized for low-voltage applications. It has typical forward voltage drop of 0.2 V, but its leakage current can be as high as 80 mA. It is being considered for a 12 V to 2.5 V converter with 50 W load.
Construct an example of the cycle of money : Construct an example of the cycle of money, identify all the players involved, and identify their individual benefits from participating in the cycle of money.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Estimate the time required to recharge a 10-a hr battery

A diode is connected in series with a 30-V rms source to charge a 12-V battery with an internal resistance of 0.1 ohm. Specify the series resistance necessary to limit the peak current to 2A. Estimate the time required to recharge a 10-A hr batter..

  Explain fundamental periods versus discrete time

A signal x[n] is formed by sampling a signal x(t) = -4sin(200*pi*t) at a sampling rate of 400Hz. Graph x[n] over 10 fundamental periods versus discrete time. Then do the same for the sampling frequencies of 60 and 200Hz.

  What is the motor efficiency as operated

What is the motor efficiency as operated?

  Determine the distance traveled by automobile

A 3000-lb automobile is driven down a 5 degree incline at a speed of 50mi/h when the brakes are applied, causing a total braking froce of 1200 lb to the applied automoble. Determine the distance traveled by automobile before it come to a stop.

  What is resistance of resistor that should be connected

A (3V, 300mA) flashlight bulb is to be used as the dial light in a 120V radio. What is the resistance of the resistor that should be connected in series with the flashlight bulb to limit the current

  What is rms voltage of source in a single loop series

3) What is the RMS voltage of the source in a single loop series circuit if Irms = 1A-30° and Ztotal = 100 65° 4) What is the power dissipated by an electric heater with a resistance of 20? drawing a current waveform of i(t) = 10 sin(60t) Amps

  Show that events a and c are independent

The lifetime of a turtle is a continuous value uniformly distributed between 50 and 150 years. Let X and Y be the lifetimes of two randomly chosen turtles, and consider the following events: A = {X

  How much current-in ampere will flow through the load

A student from electromechanical systems class planned to construct a transformer that will cause an actual load resistance of 98.5 ohms to appear as 172.8 ohms to an AC voltage source of 176 V rms.

  What is the time interval between samples

Telephone signals are typically sampled at 8000 Hz. a. What is the time interval between samples b. What is the highest frequency that can be recovered from a sampled signal

  Explain baseband digital trnamission and multi level coding

Baseband digital trnamission and multi level coding, A baseband digital data link transmits polar binary NRZ current pulses at a rate of 1.0 Msps. The link uses ideal RRC filters with roll off factor r = 0.5.

  Verify loop analysis method by multisim simulation

Scenario/Summary: At least two of the following simulations must be attempted by the student. Verify Loop Analysis Method by MultiSim simulation Verify Superpposition Theorem Method by MultiSim simulation

  Design parallel resonant circuit that capacitor can adjust

Design a parallel resonant circuit so that a variable capacitor can adjust the resonant frequency over the AM broadcast band, 535 to 1605 kHz, with Q

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd