Find the total work done by the gas in one cycle

Reference no: EM13320879

Two moles of an ideal monoatomic gas undergo a cyclic process starting from state A at a vol. of 1L and a pressure of 2 atm. It expands at constant pressure until the volume is 2.5L (state B), after which it is cooled at constant vol. until its pressure is 1 atm (state C). It is then compressed at constant pressure until its vol. is again 1 L. (state D), after which it is heated at constant volume until it is back in its original state A. Take R=8 j/molK, 1 L = 10^-3 m^3, 1 atm= 10^5 N/m^2.

A.) Draw this cycle on a PV diagram.

B.) Find the temperature in states A and B.

C.) Calc. the chang in internal energy in processes 1 (A to B).

D.) Find the total work done by the gas in one cycle.

E.) What is the change in internal energy for the entire cycle?

Reference no: EM13320879

Questions Cloud

Determine the dead uniform load in kips per linear foot : A wide flange steel beam supports a permanent concrete masonry wall, floor slab; architectural finishes mechanical and electrical systems. Determine the dead uniform load in kips per linear foot acting on the beam.

Determine normal stresses induced in steel and in concrete : The concrete post (Ec=3.6*10^6 psi and Ac= 5.5*10^-6/degrees F) is reinforced with six steel bars. each of 7/8-in diameter (Es=29*10^6 psi and As=6.5*10-6/ degrees F).

Find the maximum emf induced in the coil : In a model AC generator, a 503 turn rectangular coil 5.0 cm by 21 cm rotates at 120 rev/min in a uniform magnetic field of 0.59 T. What is the maximum emf induced in the coil

What is the ph of a buffer : What is the ph of a buffer that results when .40 mol nahco2 is mixed with 100 ml of 2.0 m hcl and diluted with water to 250 ml

Find the total work done by the gas in one cycle : Two moles of an ideal monoatomic gas undergo a cyclic process starting from state A at a vol. of 1L and a pressure of 2 atm. Find the total work done by the gas in one cycle

What is the position of the block : A 2.00 kg. frictionless block is attached to an ideal spring with force constant 300 n/m. At t=0 the block has velocity -4.0 m/s, what is the position of the block when its speed is 2.5 m/s

What is the difference in water levels between reservoirs : A wrought iron water line connecting two reservoirs at 20°C has a length of 1500 m, a diameter of 75 cm, two elbows (90º, long-radius, flanged), a fully open gate valve, and a reentrant pipe entrance.

Write a program to sort back into a single file : Write a program to sort these back into a single file. Oh, and we only have a few nanoseconds to do it, so you'd better do it with pthreads!

Determine the inductance of a solenoid : Calculate the inductance of a solenoid with 275 turns if the length of the solenoid is 30 cm and its radius is 2.5 cm

User Account

All Pages