Find the the magnitude of average drag force exerted on car

Assignment Help Physics

Reference no: EM13312113

A 7450-kg car is travelling at 28.7 m/s when the driver decides to exit the freeway by going up a ramp. After coasting 362 m along the exit ramp the car\'s speed is 13.5 m/s, and it is h = 14.9 m above the freeway. What is the magnitude of the average drag force exerted on the car?

Reference no: EM13312113

Questions Cloud

Determine what force is required to hold the shield in place : Water at 70oC (row = 1.94 slugs/ft3) flows out of a nozzle (diam. = 1in) with a velocity of 10 ft/s at an individual holding a protective shield. If the water deflects off of the shield perpendicular to the original stream in all directions

Description of the facts of the investigation and case : Need to make report on small cases- 7 cases altogether in 1 assignment. 2 assignment has 7 cases as well.

What is the maximum speed of the block : A block of mass m = 4.43 kg is attached to a spring which is resting on a horizontal frictionless table. What is the maximum speed of the block

Find how many trucks are needed to service the backhoe : A haul fleet of trucks having a heaped capacity of 15 cy. is to be loaded by a hydraulic backhoe excavator (CT=.48 min.) with a 3 1/2 cy. heaped capacity. Assume the material is a wet loam that weighs 3380 lb/cy in the bank state

Find the the magnitude of average drag force exerted on car : A 7450-kg car is travelling at 28.7 m/s when the driver decides to exit the freeway by going up a ramp. find the magnitude of the average drag force exerted on the car

Determine the elevation and stationing of the low point : A 1600-ft-long sag vertical curve (equal tangent) has a PVC at station 120+00 and elevation of 1500 ft. The initial grade is -3.5% and the final grade is +6.5%. Determine the elevation and stationing of the low point, PVI and PVT.

Inventory and lean manufacturing : Inventory and Lean Manufacturing

What is the current draw of the motor during the operation : The motor has an efficiency of 80%. It operates at 240V AC. A 12" diameter drum is attached to the gearbox output shaft, and a wire rope is wrapped around the drum to act as a winch. The winch is used to raise bucket of raw material in a factory.

Determine what is the new flowrate of the channel : The flowrate through an open channel with a slope of 2 % is calculated using Manning's equation at 100 cubic feet per second. If the slope of the channel is doubled to 4%

User Account

All Pages