Find the tension in the rope at a distance z below o

Assignment Help Mechanical Engineering
Reference no: EM131382783

A body of mass M is suspended from a fixed point O by an inextensible uniform rope of mass m and length b. Find the tension in the rope at a distance z below O. The point of support now begins to rise with acceleration 2g. What now is the tension in the rope?

Reference no: EM131382783

Questions Cloud

Find the gravitational force exerted on the sphere : A symmetric sphere, of radius a and mass M, has its centre a distance b (b > a) from an infinite plane containing a uniform distribution of mass σ per unit area. Find the gravitational force exerted on the sphere.
What does the central tendency of each variable look like : PSY K300 Statistical Techniques Final Project. You need to analyze data You need to analyze data pair 7 (counseling_debt). I have attached the data, you need to use R-studio to open the data that is attached. What does the central tendency of each ..
Calculate the length of a quarter-wave vertical antenna : Calculate the length of a quarter-wave vertical antenna for each of the following services: CB radio at 27 MHz; cordless phone at 49 MHz; FRS at 460 MHz; cellular radio at 800 MHz; and PCS at 1800 MHz.
What is the instantaneous tension in the connecting string : The tension in the tow rope is suddenly increased to 4T0. What is the instantaneous acceleration of the blocks and what is the instantaneous tension in the connecting string?
Find the tension in the rope at a distance z below o : Find the tension in the rope at a distance z below O. The point of support now begins to rise with acceleration 2g. What now is the tension in the rope?
How much you will pay for the bond if you purchased the bond : Assume that today's date is April 15, 2015. Fresh Bakery Inc. bond is an annual-coupon bond. Par value of the bond is $5,000. How much you will pay for the bond if you purchased the bond today?
Show that they will collide in less than 425 s : They are released from rest with their centres 1 m apart and move under their mutual gravitation. Show that they will collide in less than 425 s. [G = 6.67 × 10-11 N m2kg-2.]
Find the acceleration of the block : This time the frictional force F exerted on the block is given by F = µN, where N is the normal reaction and µ is a positive constant.- Find the acceleration of the block. How do the cases µ tan α differ?
Calculate spectrum use in khz per channel : Take a simplistic approach to get a rough estimate. Find the width of each RF channel and the number of voice channels per RF channel. Ignore control channels. Calculate spectrum use in kHz per channel.

Reviews

Write a Review

Mechanical Engineering Questions & Answers

  Measure the pressure inside

A mercury manometer (r = 13,600 kg/m3) is connected to an air duct to measure the pressure inside. The difference in the manometer levels is 15 mm, and the atmospheric pressure is 100 kPa.

  Knowing that at the instant shown assembly a has a

knowing that at the instant shown assembly a has a velocity of 9in.s and an acceleration of 15 in.s2 both directed

  Construct a titration curve for these data

Generate a first- and second-derivative curve for these data. 43 Does the volume at which the second-derivative curve crosses zero correspond to the theoretical equivalence point? Why or why not?

  What is the elastic modulus of the silicon

This atomic force microscope probe is a silicon beam and tip. The beam is 40 µm wide, 4 µm thick, and 130 µm long. The tip is set back 15 µm from the end of the cantilever.

  Find the force and the velocity generated by the piston

A hydraulic cylinder has a piston diameter of 2.2 inches, a fluid pressure of 1100 psi, a flow rate of 132 cubic inches per minute, and a stroke of 10.5 inches. Find the force and the velocity generated by the piston.

  The following times to failure in hours were observed in an

the following times to failure in hours were observed in an experiment where 14 units were tested until eight of them

  Find inequalities that must be satisfied by a and b

Find inequalities that must be satisfied by a and b

  The total mass of the car and its water fuel will be 5 kg

suppose that you are designing a toy car that will be propelled by water that squirts from an internal tank at 3 ms

  Calculate the equivalence ratio

Calculate the equivalence ratio, the maximum pressure and temperature achieved during the cycle, and also the composition (by volume) of the dry exhaust gas.

  Design your system to pass these frequencies

Your human interface should include buttons to trigger sound recording, stop recording, start playback, and stop playback.

  What are their compositions and amounts

Assume that the overall composition is 0.6 wt%C (and 99.4 wt%Fe) and a total weight of 10Kg. At T=727C, how many phases are present and what are their compositions and amounts?

  Final temperature of the steam and the volume of the vessel

An insulated vessel has two compartments separated by a membrane. On one side is 1 kg of steam at 400 oC and 200 bar. The other side is evacuated. The membrane ruptures filling the entire volume. The final pressure is 100 bar. Determine the final tem..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd