Find the speed of each ball after the collision

Assignment Help Physics

Reference no: EM13564859

A cue ball travelling at 5.0 m/smakes a glancing, elastic collision with a target ball of equalmass that is initially at rest. The cue ball is deflected so thatit makes an angle of 30° with its orginal direction of travel.

(a) Find the angle between the velocity vectors of thetwo balls after the collision.

°
(b) Find the speed of each ball after the collision.

cue ball m/s

target ball m/s

Reference no: EM13564859

Questions Cloud

Calculate the normal stress ab in the upper part of the post : A hollow circular post ABC supports a load P1 = 1700 lb acting at the top. A second load P2 is uniformly distributed around the cap plate at B. The diameters and thicknesses of the upper and lower parts of the post are dAB= 1.25 in, tAB= 0.5 in, dBC=..

Plot the three values on the same diagram and comment on the : A wave has a height of 1.5 m in water 5 m deep and a wave period of 6 s. Plot the horizontal component of velocity, the vertical component of acceleration, and the dynamic pressure at a point 2 m below the still water level versus time for a 6-s inte..

Determine the average shear stress on the bolt surfaces that : Two bolts are used to form a joint connecting rectangular bars in tension. The top and bottom pull to the left with 10 kips each, the middle part 20 kips to the right. The bolts have a diameter 3/8 inch, determine the average shear stress on the bolt..

Determine the energy removed from the air after it is cooled : Moist air at standard conditions is at a dry bulb temperature of 80 degree F and a relative humidity of 50%. It is cooled to 50 degree F. Use the psychromtric chart to determine:

Find the speed of each ball after the collision : A cue ball travelling at 5.0 m/smakes a glancing, elastic collision with a target ball of equalmass that is initially at rest. Find the speed of each ball after the collision

What is the average horsepower output of the engine : When gasoline is burned, it gives off 46,000 J/gram of heat energy. what is the average horsepower output of the engine

What temperature change is required to return the 100-mm : The elastic modulus is 40 GPa, the yield stress is 150 MPa, the ultimate stress is 525 MPa, and the ultimate strain is 0.38 (mm/mm). Perform the following tasks for this material.

Evaluate what impulse was given to the ball by the floor : a ball of mass 0.150 kg is dropped from rest from a height of1.25m. It rebounds from the floor to reach a height of 0.960m. What impulse was given to the ball by the floor

Find the residual chemical concentration and the amount : A chemical is added at the beginning of a water treatment plant at a dose of 750 lb/day. The water treatment plant provides water to a community of 200,000 people and the average water consumption in the city is 110 gallons per capita per day (gpcd).

User Account

All Pages