Find the specific gravity of soil

Assignment Help Civil Engineering
Reference no: EM132416225

Problem: The mass specific gravity of a fully saturated specimen of clay having a water content of 40% is 1.88. On oven drying, the mass specific gravity drops to 1.74.

Required:

Question: Find the specific gravity of soil.

Reference no: EM132416225

Questions Cloud

Find the relative density of soil : In the laboratory the voids ratios in the loosest and densest states were found to be 0.642 and 0.462 respectively. Find the relative density of soil.
Safe internal pressure that can be allowed in penstock : The plates are secured by 8 mm size fillet weld provide on inside and outside of the lapped ends. Determine safe internal pressure that can be allowed
Inheritance of genetic disorders : This unit we are learning about the inheritance pattern of genetic disorders. Some disorders require only a single copy of a mutated gene;
Osha requirements for protecting workers : What three methods meet OSHA requirements for protecting workers in an excavation when worker protection against cave-in is required?
Find the specific gravity of soil : The mass specific gravity of a fully saturated specimen of clay having a water content of 40% is 1.88. On oven drying, the mass specific gravity drops to 1.74.
Find the minimum set back from the building : Find the minimum set back from the building to centre line of road if the radius of centre line of road is 600 m and sight distance is 200m.
Differentiate in sterilization and commercial sterilization : Explain and differentiate between sterilization and commercial sterilization. What organism does commercial sterilization aim to destroy?
What is the purpose of piles : What is the purpose of piles, and why they could be more preferred compared to shallow foundations.
What is the modulus for the rod : Problem: A rod consisting of a matrix and reinforcing fibers has the following properties: (a) What is the modulus for the rod?

Reviews

Write a Review

Civil Engineering Questions & Answers

  A simply supported square timber beam is span 50m and

a simply supported square timber beam is span 5.0m and spaced 3.0m the dead load and imposed load was found to 1.5knm2

  How the station has been designed to function efficiently

CEGE0003 - Civil Engineering Design - University College London - Civil Engineering Design Study - How the station has been designed to function efficiently

  How the extent of martensite formation may be increased

Name the three factors that influence the degree to which martensite is formed throughout the cross section of a steel specimen. For each, tell how the extent of martensite formation may be increased.

  Determine what is the balance delay for the solution

A proposal has been submitted to replace a group of assembly workers, each working individually, with an assembly line. The following table gives the individual work elements. The demand rate for this job is 1600 units/week (assume 40h/week)

  Which of materials listed in table are possible candidates

A cylindrical rod with a length of 380 mm and a diameter of 10 mm is to be subjected to a tensile load. The rod must not experience plastic deformation or an increase in length of more than 0.9 mm when a load of 24.5 kN is applied.

  Determine the values of the stress and the change in the

A rectangular steel plate with thickness t=0.625 inches is subjected to normal stresses sigma x and sigma y.The strain in the x direction is known to be 0.00065 and the strain in the y direction is known to be 0.0004

  What is the probability that the second explosion

Cities cover approximately 0.5% of the Earth's land area, which itself constitutes 29% of the total surface of the planet. What is the probability that the second explosion in part (b) occurs over a city? Assume an equally likely probability of im..

  What is the first order decay coefficient in day-1

A tank operated as a CFSTR used to remove benzene from a flow stream is 1500 m3 in size. The flow rate in and out of the tank is 8 m3/day. If the influent benzene concentration of 265 ug/L and the effluent concentration is 12 ug/L

  What would be her recoil velocity

In a football game, a receiver is standing still, having just caught a pass. Before he can move, a tackler, running at a velocity of +3.1 m/s, grabs him. The tackler holds onto the receiver, and the two move off together with a velocity of +1.6 m/s

  How do you get the equations for the elastic curve using

A grit chamber is designed for a flow-through velocity of 0.30 m/s, a depth of 0.9 m, and a length of 10.5 m. If inorganic particles have a specific gravity of 2.65, estimate the diameter of the largest particle that can be removed 100% at 20 degrees..

  What woods were used and how were they sawn

Make measured drawings of millwork details in an older building that you admire. Analyze each detail to discover its logic. What woods were used and how were they sawn? How were they finished?

  Determine the required properties using ees software

Reconsider Prob. 14-46. Determine the required properties using EES (or other) software instead of the psychrometric chart. What would the property values be at a location at 3000 m altitude?

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd