Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A binary phase-shift keyed signal has a bit rate of 100kbits/s and a carrier frequency of 2400MHz. The message waveform uses a root-raised-cosine line code with α=1. The bandpass filter in the receiver front end has a rectangular frequency response with a bandwidth equal to the absolute bandwidth of the received signal.Suppose a probability of error of Pe = 10^-5 is required.A. find the minimum value of Eb/NoB. the antenna noise temperature is 290K, and the LNA has a noise figure of 1.6dB. Find the noise power spectrum Sn(f) = No/2 referred to the LNA input.C. Find the received signal power needed to ensure the required probability of error.D. Find the signal-to-noise ratio at the bandpass filter output.
Calculate and plot the required current and the resulting voltage Va that should be applied to the armature terminals of the machine. As intermediate steps, calculate and plot Ea, the required electromagnetic torque Tem from the motor, and the cur..
Describe a passive fourth-order Butterworth filter with cutoff frequency of 2000 radians per second and an output resistor of 1000 ohms.
a plane wave is obliquely incident onto the planar interface between mismatched, lossless, nonmagnetic, uniform media, yet undergoes no reflection. If incidence is at 54 degrees to the normal, at what angle to the normal does the transmitted wave ..
A liquid level system converts a 4-10 m level into a 4-20mA current. Design a three mode controller (PID im assuming) that outputs 0-5 volts with 50% PB, 0.03 min integration time, and 0.05 min derivative time. Fastest expected change time is 0.8 ..
Compare the performance of the basic latch (build with 74LS00 NAND gate), the master-slave flip-flop (7476), and the edge-triggered flip-flop (74LS76). What are the advantage and disadvantage of each design
A point charge of 20 [nC] is located at (4,-1,3), and a uniform line charge of -25[nC/m] lies along the intersection of the planes x=-4 and z=6. (a) Calculate D at (3,-1,0). (b) How much electric flux leaves the surface of a sphere of radius 5, ce..
Obtain an expression for the spectrum of an FM signal with single-tone modulation where the carrier amplitude is Ac, the carrier frequency is Fc, the message frequency is fm and the modulation index is B (beta).
To digitally manipulate information we must encode it using binary numbers. Consider an encoding for playing cards. There are 52 cards in a deck and they are divided
State Carson's rule for bandwidth estimation. What does it reduce to for NBFM and WBFM and d erive an time domain expressionfor the output xd(t) of the system
a. Functionally, how do closed-loop systems differ from open-loop system b. State one condition under which the error signal of a feedback control system would not be the difference between the input and the output.
A 1 W power source is connected to the input of a directional coupler with C=20 dB, D=35 dB, and an insertion loss of 0.5 dB. Find the output powers (in dBm) at the through, coupled, and isolated ports. Assume all ports to be matched.
500W lighting is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7A. What is the inductance of the load connected in parallel with incandesent lights. Assume a voltage of 120v and 60hz.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd