Find the resistance r and inductance l of the motor

Assignment Help Electrical Engineering
Reference no: EM131202943

A motor is connected to a 120 V rms, 60 Hz line. The motor is rated at 2 kVA and operates with a power factor of 0.8.

(a) Find the apparent and real power.

(b) What is the current flowing into the motor?

(c) Find the resistance R and inductance L of the motor.

Reference no: EM131202943

Questions Cloud

Common stockholders will receive dividend : A corporation has 10,000 shares of 6% $50 par value cumulative preferred stock and fifty thousand shares of $4 par value common stock outstanding last year no dividends were paid this year the board of directors decided to pay a dividend of $80,000 t..
Calculate the value of c to achieve this condition : It is desired to run the motor in the previous problem with a power factor of unity. To achieve this, a capacitor C is connected in parallel across the motor, which results in a circuit like that shown in Fig. 2.13. Calculate the value of C to ach..
Program to find the sum & average of the given numbers : Write a program to find the sum & average of the given numbers using the while loop.- Write a program in C to find the sum and average of the given numbers stored in an array of n values.
Create appropriate x- and y-axis labels : Create appropriate X- and Y-axis labels, a chart title, and data labels so that your chart data are appropriately identified (years, dollars, account territory, etc.)
Find the resistance r and inductance l of the motor : A motor is connected to a 120 V rms, 60 Hz line. The motor is rated at 2 kVA and operates with a power factor of 0.8.
What stereotypes are associated with middle age : Describe Erik Erikson's Generativity versus Stagnation stage. According to Erikson, how does personality change in middle age? What personal and cultural forces motivate generativity? Why does it increase and contribute vitally to favorable adjust..
Their respective voltages is : The ratio of resistances of a 100 W, 220 V lamp to that of a 100 W, 110 V lamp will be at their respective voltages is?
Using the units-of-production method-depreciation expense : A company purchased a weaving machine for $307,320. The machine has a useful life of 8 years and a residual value of $17,000. It is estimated that the machine could produce 764,000 bolts of woven fabric over its useful life. In the first year, 112,00..
Calculate the forward bias needed at room temperature : Calculate the forward bias needed at room temperature on a germanium pnjunction to give a current of 10 mA. Use a reverse saturation current of Io = 10-6A.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  What is a node based on electrical waves

What is a node based on electrical waves and physics and its difference with antinode.

  Determine the worst case propagation delay

determine the worst-case propagation delay for your combinational multiplier. You can assume that the delay through every full adder is tpd.

  Find how much energy in kilowatt hours is initially stored

How much energy in Kilowatt hours is initially stored in the battery If the battery costs $75 and has a life 0f 300charge-discharge cycle, what is the cost of the energy in dollarsper kilowatt hour Neglect the cost of recharging the battery.

  What is the minimum necessary bit rate of the data line

The Bandwidth of a broadband signal is 6 MHz and it's maximum frequency is 106Mhz. What is the most likely carrier frequency. WHich of the follwing is not a fundamental characteristics determines the effectiveness of a communication system.

  Determine generated voltage nd developed torque at full load

a DC shunt machine ( 24kW, 240V, 1000 RPM) has Ra= .12 ohms, Nf= 600 turns/pol. The machine is operated as a seperately excited dc generator and is driven at 1000 RPM. When If = 1.8 amps the no load terminal voltage is 240V.

  How much resistance should be inserted in series with meter

you are an electrician on the job. you have been given a multimeter that has the following AC voltage ranges: 30,60,and 150. the meter states that it has a resistance of 5000ohm/v. you need to be able to measure a voltage of 277 volts.

  Determine what is the total three-phase load

A factory is to be supplied with 408Y/277 3 phase, 4 wire electrical service. The total estimated single-phase load is 25 kW, at .9 lagging power factor. The total estimated three-phase load is 250 kW at .85 lagging power factor.

  Explain what is the maximum message bandwith

What is the maximum message bandwith for which the system operates satisfactorily? Determine the output signal to quantizing noise ratio when a full-load sinusoidal modulating wave of frequency 1 MHz is applied to the input.

  Find two designs using open-circuited stubs

Find two designs using open-circuited stubs.

  What are some of the benefits of smart grid application

In the presentation, "IT and Smart Grid" the presenter, Dr. Peter Will, provided several definitions of "smart-grid". Provide your definition of smart-grid the way you understand it. What are some of the benefits of "smart grid" application

  Find the number of electrons stored on one plate

In actual electronic work, capacitances range from 30 picofarads, to 60 microfarads, to 5 farads. Assuming that each of these capacitances is charged to five volts, find for each a) the stored charge in coulombs

  Design a 2-way set-associative cache with 16-byte cache line

The penalty for main memory access is 100 clock periods for both data and instructions. The probability of an instruction cache miss is 2%. The probability of a data cache read miss is 5%. The data cache has a write-back

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd