User Account

All Pages

Find the reserve capacity of the plant

Assignment Help Electrical Engineering
Reference no: EM131250864

A generating station has a maximum demand of 25MW, a load factor of 60%, a plant capacity factor of 50% and a plant use factor of 72%.

Find (i) the reserve capacity of the plant (ii) the daily energy produced and (iii) maximum energy that could be produced daily if the plant
while running as per schedule, were fully loaded.

Reference no: EM131250864

Questions Cloud

Calculate its annual load factor : A 100 MW power station delivers 100 MW for 2 hours, 50 MW for 6 hours and is shut down for the rest of each day. It is also shut down for maintenance for 45 days each year. Calculate its annual load factor.
Direct grant of non-labor income : One way of aiding low-income families is to increase the minimum wage. An alternative is to provide a direct grant of non-labor income. Compare the impact of these two options on work incentives.
Substitution effect is greater than the income effect : Indicate in each of the following instances whether specified events would cause a worker to want to work more or fewer hours:
What is the expected value of each lottery : Suppose you have a choice between having an income of 300 with certainty and a lottery that makes your income equal to 400 with probability 0.5 and equal to 200 with probability 0.5.
Find the reserve capacity of the plant : Find the reserve capacity of the plant, the daily energy produced and maximum energy that could be produced daily if the plant while running as per schedule, were fully loaded.
What is expected wealth : Samantha often forgets to lock her house. This has caused the probability of a burglary to be 30%. If her house gets broken into, she faces a property loss of $10,000, otherwise she gets to keep her $100,000. What is her expected wealth?
Understanding temperament in children : PSY2DEV 2016 - This section clearly re-states the findings and interprets them for the reader, showing how they fit with (or don't fit with) what was expected in the current study, and what previous studies have shown.
Probability of the sample average number : On a particular day during the most recent golf tournament, the organizer placed the hole (pin) in the back left corner of the green. 36 golfers played the hole with the new placement on that day. Determine the probability of the sample average nu..
What are the available cam treatment options for cancer : What are the available CAM treatment options for cancer? What should cancer patient do when using and considering CAM therapies

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the sending-end voltage and current

The 765-kV 3φ line is 400 mile long and delivers 100 MW at 750 kV at 95% power factor lagging. Find the sending-end voltage and current and the transmission efficiency. Use the long-line model. Series impedance z = 0.02 + j0.54?/mi, shunt admittan..

  Calculate the new overall gain if the gain of the amplifier

The overall gain of a -ve feedback amplifier is 100. If the gain of the amplifier device itself is 1000. a) find the loop gain b) calculate the feed back factor β c) how much percentag error results if the overall gain is estimated from β alone

  Which pml performs better at low frequencies and why

D rectangular resonator. Write a 3D FDTD algorithm using Equations (4.18) and (4.19) in a 100 × 50 × 20 m box with perfectly conducting walls.

  What is the instantaneous frequency

An MSK system has a carrier frequency of 10 MHz and transmits data at a rate of 50 kbps.

  At what distance along the central perpendicular axis of

at what distance along the central perpendicular axis of a uniformly charged plastic disk of radius 0.6m is the

  Why the noise level is much lower than the signal

A signal is sampled every 1ms for 20ms, with the following actual values of the analogue voltage at successive sampling times. Plot the values of the voltage recorder by a 5 volt, 4 bit ADC assuming that the noise level is much lower

  Design an elevator controller for simple two-floor elevator

Design an elevator controller for a simple two-floor elevator. On the 1st floor, there is only an up button, and on the 2nd floor, there is only a down button. Within the elevator, there are two buttons: door open and door close.

  Determine the power this amplifier will deliver to resistor

a). Determine the power this amplifier will deliver to a 4 ohm load, to an 8-ohm load, and to a 1K-ohm load b). What would be the open-circuitvoltage of the amplifier if the signal level were increased

  Find a figure that shows how to wire such an arrangement

Many hallway and some room lights are wired so that they may be controlled from either end of the hall or room. This is called a two-way or three-way switch (references vary). Explain why this is equivalent in operation to an XOR gate.

  Calculate the assembly energy for the configuration

Four equal point charges Q form a square of side length a. Calculate the assembly energy for this configuration.

  What is capacitance resolution of digital measurement

determine the displacement noise of the sensor with the electrodes at a position midway between maximum andminimum separation if the output signal is filtered to provide bandwidth of 10, 100, and 1000 Hz

  Find a voltage waveform and current waveform

The average power is not necessarily equal to the average current times the average voltage. To show this, find a voltage waveform and current waveform where each has a zero average value but their product has a non-zero value.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

Submit Assignment

Academics

Major Subjects

Majors

Get In Touch

whatsapp: +1-415-670-9521

Phone: +1-415-670-9521

Email: [email protected]

TERMS & POLICIES

HELP & SUPPORT

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd