Find the required minimum area for the heat transfer neglect

Assignment Help Civil Engineering

Reference no: EM13543377

1.Saturated liquid water at 1000 kPa flows at 2 kg/s inside a 10 cm outer diameter steel pipe and outside of the pipe is a flow of hot gases at 1000 K with a convection coefficient of h = 150 W/m2 K. Neglect any ?T in the steel and any inside convection h and find the length of pipe needed to bring the water to saturated vapor.

2.A large condenser (heat exchanger) in a power plant must transfer a total of 100 MW from steam running in a pipe to sea water being pumped through the heat exchanger. Assume the wall separating the steam and seawater is 4 mm of steel, conductivity 15 W/m K and that a maximum of 5°C difference between the two fluids is allowed in the design. Find the required minimum area for the heat transfer neglecting any convective heat transfer in the flows.

Reference no: EM13543377

Questions Cloud

How do you calculate maximum external pull in each gear : A 180 lb man and a 120 lb woman stand at opposite ends of a 300 lb boat, ready to dive, each with a 16 ft/s velocity relative to the boat. Determine the velocity of the boat after they have both dived, if the woman dives first, and if the man dives f..

Calculate and plot the distribution of total and effective : Calculate and plot the distribution of total and effective vertical stresses as well as pore-water pressure with depth from the ground surface up to the bedrock surface.

Determine the lrfd nominal and adjusted design values : Problem: Determine the LRFD nominal and adjusted design values and adjusted design resistances for the following members and loading combinations. All members are Select Structural Southern Pine and are fully braced to prevent lateral torsional bucki..

Determine the adjusted asd values associated with the : Problem: A 24F-V4 Douglas Fir-Larch glulam is used to span 32 ft, carrying an ASD load combination (D+S). The load is uniform over a simple span, and the beam is laterally supported so that lateral torsional buckling is prevented.

Find the required minimum area for the heat transfer neglect : Saturated liquid water at 1000 kPa flows at 2 kg/s inside a 10 cm outer diameter steel pipe and outside of the pipe is a flow of hot gases at 1000 K with a convection coefficient of h = 150 W/m2 K

Determine the asd reference and adjusted design values for : Determine the ASD reference and adjusted design values for the following members and loading conditions. All members are Select Structural Southern Pine and are fully braced to prevent lateral torsional buckling. Bending Occurs about the strong axis.

Determine the variation of jet are with elevation : A 60 -m- long steel wire must not strech more than 48mm when the tension in the wire is 6 kn. Knowing that e-200GPa, determine (a)the smallestdiameter which may selected for the wire,(b)the corresponding value of the normal stress.

Historical treatment of children and juvenile justice system : Juvenile Delinquency, and the Interactive Module, "Historical Treatment of Children and Juvenile Justice System. "

How many tons of aggregate will be needed : The allowable stress in a steel shaft with an outside diameter of 1.5in and an inside diameter of 1.1in is 12,000psi. What hp can the shaft deliver at 1750rpm?

User Account

All Pages