Find the proper diameter pipe to the nearest

Reference no: EM13532286

You are asked to design a pump station to conveywaste water at a flow rate of 250 cubic meters per hour to anequalization tank. A velocity of at least 3ft/s must be maintained in the pipe to prevent deposition and provide scouring of any previously deposited solids. However, a maximum velocity of 10ft/sis prescribed to prevent oversizing the pumps. Due to the nature ofthe waste water, you want to target the high end of this range.Find the proper diameter pipe to the nearest 2" to achieve thisdesign objective.

Reference no: EM13532286

Questions Cloud

Determine the resultant of the four force sand its line of : Four forces act on a small airplane in flight: its weight (24kN), the thrust provided by the engine (10 kN), the lift providedby the wings (23 kN), and the drag resulting from its motionthrough the air (3 kN).

What is the elevation of point q : The slope distance and zenith angle measured from point P to pointQ were 1876.253m and 87.33'24 degrees, respectively. The instrumentand rod target heights were equal. If the elevation of point P is227.965m, above datum, what is the elevation of poin..

Determine the perpendicular distance d from the line to the : A line passes through the points (20m, 16m) and (-1m, -4m). Determine the perpendicular distance d from the line to the origin O of the system of coordinates.

An observer fails to check the bubble and it is off two : A piston-cylinder device initially contains 1.4 kg saturatedliquid water at 200 C. Now heat is transferred to the water until the volume quadruples, and the cylinder contains saturatedvapor only.

Find the proper diameter pipe to the nearest : You are asked to design a pump station to conveywaste water at a flow rate of 250 cubic meters per hour to anequalization tank. A velocity of at least 3ft/s must be maintained in the pipe to prevent deposition and provide scouring of any previously d..

Determine the pressure rise in the tire when the air : The pressure in a tire depends on the temperature of the air in atire. When the air temp is 25 C, the pressure gage reads 210KPa. If the volume of the tire is 0.025 m3

Negate friction at the gate hinge and the pulley : A 1-m diameter cylindrical mass, M, is connected to a 2-m widerectangular gate. The gate is to open when the water level,h, drops below 2.5 m. Determine the required value forM. Negate friction at the gate hinge and the pulley.

Find the product of two hexadecimal integers : Determine the base of the following arithmetic operation(assume that the base fo the stystem is x)

Determine ? so that the avg stress : Determine θ so that the avg. stress in AC is twice thatof AD. What is the magnitude of stress in each rod? The diameter of each rod is as follows: AD 0.3in, AC 0.25in, AB0.35in

User Account

All Pages