Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A parallel-plate wave guide consists of two perfectly conducting plates spaced 1 inch apart. Find the propagation constant and the guide wavelength for the modes TE1 and TE2 at
(a) 5 GHz(b) 15 GHz
The rotor of a 4 pole generator is wound with a 100 turn coil. If the flux per pole is 4.5mWb and the rotor turns at a speed of 1800 rpm, determine (a) The frequency of the induced voltage in the rotor.
Design a circuit with input p and output f that will output f = 1 if the past three inputs (not including the current input), formed either 010 or 000. Otherwise, f = 0. Note: This is a Moore-type finite-state machine.
We would like to monitor the first two least significant bits of PORTB (use masking technique). Whenever both of these bits are set, switch all LEDs of Port A on for one second. Assume that the name of the delay subroutine is DELAY.
Two bar magnets are placed in a straight line with their morth poles 5 cm apart. (a) what is the force of repulsion if M1=25.1*10^-5 Wb and M2=6.28*10^-5 Wb. (b) what is the field intensity at the M2 north pole as a result of the M1 north pole.
What is the different of having op-amps with different amount of poles, as an example some one come to you and offer you this new opamp, but this person tell you that this op-amp jus have two poles in its open loop response
A 75- ohm lossless transmission line is interfaced to a load impedance that consists of a series connected resistor of 30 ohm and a capacitor of 10 pF. At an operating frequency of 2 GHz and for a wavelength of 10 cm.
A spread-spectrum acquisition system uses a serial search scheme.The synchroniser integrates the squarer output for interval of 0.1s and the synchroniser output is sampled at intervals of 0.05s . The probability of false alarm is 0.064255 .
A thin conducting wire of length 3w forms a planar equilateral triangle. A Direct current I flows in the wire. Find the magnetic flux density at the center of that triangle.
A sequential circuit had on flip flop Q, two inputs x and y, and one output S. It consists of a full adder circuit connected to a D flip flop, derive the state table and state diagram of the sequential circuit.
Dynamic RAM that must be given a refresh cycle 64 times per ms. Each refresh operation requires 150 ns. memory cycle requires 250 ns.
a. Describe the operation of a typical NMOSFET transistor used both as an amplifier and a switch. b. List the 3 regions of operation and draw the I-V characteristic curve. c. Show the effect of channel length modulation on your graph.
Determine the RMS generated voltage of an alternator used for a 50 Hz system if it has a flux per pole of 0.015 Wb, 72 turns per phase and a winding constant of 0.96
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd