Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
two λ/2 dipoles are placed parallel to each other and spaced by a distance d = .15 λ , they are fed with antiphase currents so that I2=-I1=.7 Ampere ,
i- find the power radiated by the system taking into account the mutual impedance betwen the dipoles [Zm= [58-j10]ohm .ii- what is the maximum radiated E-field relative to that of a single λ/2 dipole ?
What will be the total impedance of a series circuit having a resistor of 100 ohms, an inductor of 200 ohms reactance, and a capacitor of 300 ohms reactance. Also, what will be the dissipated power when voltage source is 10sin1000t.
The above transformer is to be connected as an auto transformer to supply a load at 120 V from 210 V source. What kVA load can be supplied without exceeding the current rating of the windings
Assume that the radius of the sun is 6.955x10^8 m and that the mean distance of the sun from the earth is 149.6x10^9m A.what is the diameter of the solar disk on the SAM projection screen
A 200 nm oxide film is deposited on a 500 m thick bare silicon wafer that has a radius of curvature of 300 m. After deposition, the radius is measured to be 200 m. A 600 nm nitride film is now deposited on the oxide
two resistors with nominal values of 4.7K ohm and 10K ohm, are used in a voltage divider with a +15V supply to create a nominal +10V output. Assuming the resistor values to be exact, what is the actual output voltage produced
The IC differential amplifier is to be fabricated in a CMOS technology having the technology specifications of Kn' = 200 uA/V. Kp' = 100 uA/V. Vtn = 1V Vtp = -1V Va = 50V L = 1u. Calculate all the device widths for a constant bias current of 1mA
How much power (in watts) is transferred to or from the inductor when the time is 1 ms? The current flowing through the inductor is given by 5e^-200t The inductance is 107 mH
The voltage drops across three resistors in series are measured to be 10.0V, 15.0V, and 25.0V. If the largest resistor is 47.0ohm, what is the value of the smallest resistor
Phosphorous is an n-type dopant in Si since it introduces extra electrons to Si (an P atom has 1 more valence electron than Si). It is widely used in making semiconductor devices (p-n junctions for example).
A DSSS-CDMA signal has a chip sequence that is 10,000 chips in length. The sequence repeats every millisecond. What is the chip rate?
If the total power amplification through the receiver stages is G_R find the output power of the receiver. If the noise power at the output is identical to the noise power at the input of the receiver, find the NF for the receiver.
From the 1H NMR perspective, the human body is composed primarily of fat hydrogens and water hydrogens (H2O). The resonance frequency difference between the NMR signal from these two types of hydrogens is approximately 220 Hz on a 1.5 Tesla imager..
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd