Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1.A venturi water meter with a throatof 6 in registers a presssure head difference of 128 in of water between the inlet and throat. calculate the quantity of flowthrough the meter using a discharge coefficient of.93.
2.a rapid mix tank equipped with mechanical mixers will be used to mix the coagulant alum into water at 10 degree in 10 seconds with a root mean velocity gradient of 800s^-1 for a flow of 10 mgd. find the power of the mixer motor assuming it oprates at 70% officeiency.
Measurements of water-balance components have been made for a one-year period on a lake with an area of 4.4 km2 with the following results: P = 350 mm, Qsi = 2.33 x 107 m3, Qgi = 2.2 x 105 m3, Qgo = 0.6 x 105 m3, and Qso = .10 x 107 m3.
Assume that you have a constant diameter pipe that has no pumps or turbines connected to it.Prove that the fluid in the pipe will flow from a location with high piezometric pressure to one with low piezometric pressure.
Write a program that will ask for the part number for two different parts (i.e. PX_12345, and ABC_329). Display these parts in ONE message box, in numerical order (i.e. the segment of the part number to the right of the underscore character).
The investigation results indicated that the clay had a saturated density of 1.6 Mg/m3, an average initial void ratio of 1.8 and the preconsolidation pressure at the mid depth of the clay layer was 20 kPa.
Apiece of corroded steel plate was found in a submerged ocean vessel. it was estimated that the original area of the plate was 62.5cm 2 and approximately 2.8k had corroded away during the submersion.
Also calculate the deflection of the beam to check that it complies with the design limit of L/200. Only variable actions are required for deflection check.
If I raise a 1000 lbf weight 100 feet above sea level on earth in 10 seconds how much power will be required
HOCL is added to water in a tank as a disinfectant. After equilibrium is reached it is found that the pH of the water in the tank is 8.2 and the gas phase partial pressure is the head space of the tank is 0.2E-7 atm.
(a) Determine the distance d to the point where he lands. (b)What are the magnitudes of his components of velocity parallel and perpendicular to the 45 degree surface just before he lands
Water is flowing from a higher to a lower reservoir through a 24-inch pipe that has a Darcy friction factor of 0.02. The local loss coefficients for the bends, entrances, and exits sum to 3.5.
FeCl3 is added to remove excess phosphate. The following reactions occur (the charges are in parentheses): FeCl3 -> Fe(3+) + 3Cl(-) Fe(3+) + PO4(3-) -> FePO4 The equilibrium constant for the second reaction is 10^26.4.
A new sports car has a drag coefficient of .30 and a frontal area of 21 ft^2, and is traveling at 110 mi/h. How much power is required to overcome aerodynamic drag if p=.002378 slugs/ft^3?
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd