Find the power factor and the average power

Assignment Help Physics
Reference no: EM13565379

A 50.0-Ω resistor is connected to a 30.0-μFcapacitor and to a 60.0-Hz, 100-V (rms) source.

a. Find the power factor and the average power delivered to the circuit.

b. Repeat part (a) when the capacitor is replaced with a0.300-H inductor.

Reference no: EM13565379

Questions Cloud

Define what is the ph at the equivalence point : We are titrating 21.42 mL of 0.3711 M hypobromous acid (HOBr, Ka = 2.000x10?9) with 0.5076 M LiOH. What is the pH at the equivalence point
Calculate the minimum kinetic energy of the electron : An electron is trapped somewhere in a molecule which is 5.8nmlong. Calculate the minimum kinetic energy of the electron
Mirror is facing dueeast and ray of sunlight strikes mirror : A small mirror is attached to a vertical wall, and it hangs adistance of 1.59 m above the floor. The mirror is facing dueeast, and a ray of sunlight strikes the mirror early in the morning and then again later in the morning. The incident andrefle..
Define specific heat and density of the resulting solution : Assume that the specific heat and density of the resulting solution are equal to those of water [4.18 J/(g \degrees Celsius}) and 1.00 g/mL] and that no heat is lost to the calorimeter itself, nor to the surroundings.
Find the power factor and the average power : A 50.0-Ω resistor is connected to a 30.0-μFcapacitor and to a 60.0-Hz, 100-V (rms) source. Find the power factor and the average power delivered to the circuit
Explain how many moles of hydrogen gas occupy : How many moles of hydrogen gas occupy a volume of 559mL at standard temperature and pressure
Final speed of the two-object system after the collision : One object is at rest, and another is moving. The two collide ina one-dimensional, completely inelastic collision. In other words,they stick together after the collision and move off with a commonvelocity. Momentum is conserved.
Define what is the density of solid tungsten : Tungsten has a boy-centered cubic unit cell and an atomic radius of 141 pm. What is the density of solid tungsten.
How long would it take for an angular speed to triple : A torque of 500Nm is applied to a turbine rotating at 200rad/s. How long would it take for an angular speed to triple

Reviews

Write a Review

Physics Questions & Answers

  What frequency does the motorcyclist hear

A motorcycle and a police car are moving toward one another. The police car emits sound with a frequency of 532 and has a speed of 25.5. The motorcycle has a speed of 12.50. What frequency does the motorcyclist hear in this case?

  What is the final operating temperature of the filament

The potential difference across the filament of a lamp is maintained at a constant level while equilibrium temperature is being reached. It is observed that the steady-state current in thelamp is only one-ninth of the currentdrawn by the lamp when..

  Calculate how much heat is rejected each cycle

An engine with an output of 267.0 W has an efficiency of 39.0 %. It works at 9.00 cycles/s. How much heat is rejected each cycle

  Compute the angle of refraction for each wavelength

The index of refraction for crown glass is 1.512 at a wavelength of 660 nm (red), whereas its index of refraction is 1.530 at a wavelength of 410 nm (violet), what is the angle of refraction for each wavelength

  What angular speed must such a cylinder

How long would it be on the incline before it arrives back at bottom.

  Find out the time taken by the projectile

A projectile is shot from the edge of a cliff 115m above ground level with initial speed of 65m/s at an angle of 35 degrees with the horizontal.

  Determine the current in the inductor

An inductor has an inductance of 0.015 H. The voltage across this inductor is 49 V, What is the current in the inductor

  Question1a block with mass m 53 kg is attached to 2

question1a block with mass m 5.3 kg is attached to 2 springs with spring constants kleft 33.0 nm and kright 49.0 nm.

  Find the amount of heat generated when the ball hits floor

A 450g rubber ball is dropped from 2.0m above the floor. After the bounce, the ball only rises to a height of 1.5m above the floor. find the amount of heat generated when the ball hits the floor

  How much does the car body rise on its suspension

A 1000 kg car carrying four 76 kg people travels over a rough "washboard" dirt road with corrugations 4.0 m apart which causes the car to bounce on its spring suspension. The car bounces with utmost amplitude when its speed is 18 km/h. The car now ..

  Law of conservation of energy for this process putting

A 200KeV electron (i.e., an electron having kinetic energy of 200KeV) collides with a 200KeV positron (a particle with opposite charge of electron but) moving in the opposite direction in a head-on collision.

  Calculate the fraction of the maximum intensity

a double slit is illuminated with 656.3 nm light the screen is located 80 cm from the slits, calculate the fraction of the maximum intensity 0.6 cm from the central maximum

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd