Find the percentage of aceticacid ionized in the solution

Assignment Help Civil Engineering
Reference no: EM13534531

One liter of a solution is made by adding 3grams of acetic acid (HAc) to distilled water. The molecular weightof acetic acid is 60.052. The acid dissociation constant for aceticacid is KA= 1.75 x 10-5. The chemical equation for thedissociation of acetic acid into hydrogen ions and acetate ions isH+ + Ac-. Find the percentage of aceticacid ionized in the solution.

Reference no: EM13534531

Questions Cloud

The horizontal distance between the point : The elevtion of M is 875 . a transit was set at point M and a leveling rod was held vertically at point N. the horizontal cross line of the telescope was inclined so the reading of the horizontal cross line
How are you to tell what the reynols number is : A rectangular concrete channel 4m wide on a slope of 0.002 is designed to carry water(T = 10 C) at discharge rate 25m^3/s. Estimate the uniform flow depth for these conditions?
How do you find this answer : A 14in diameter pipe pile is driven 50ft into a dry loose sandwhose unit weight is 105 pcf. The angle of internal frictionis 33 degrees. Compute the safe axial downward loading
What will be the grade elevation at station : The grade elevation at station 25+00 is to be 946.52 ft. What will be the grade elevation at station 34+86.20 if the grade linerises at the rate of 1.785% between these two points?
Find the percentage of aceticacid ionized in the solution : One liter of a solution is made by adding 3grams of acetic acid (HAc) to distilled water. The molecular weightof acetic acid is 60.052. The acid dissociation constant for aceticacid
Determine the pressure at a stagnation point on that stream : At a given point on a horizontal streamline in flowing air, thestatic pressure is -2 psi (ie vacuum) and velocity is 150 ft/s.Determine the pressure at a stagnation point on thatstreamline?
What would be the concentration : What is the aqueous phase CO2 concentration (mg/L) of a watersample that is not in equilibrium with the atmosphere and has a pH= 7.1, an alkalinity of 300 mg/L and a temperature of 25 degrees C?
While the head surveyorheld .62 ft. what is the distance : Using Fy=50ksi, select the lightest available section for the spanand loading shown. Consider moment and shear only and neglect beamweight in all calculations. The member is assumed to have fulllateral bracing.
Determine that displacement and the distance traveled : The price of oil in 2005 was $67 per barrel. "This priceis still lower than price of in 1981" says a government publication. If inflation has average 3.2% per year from 1981 to2005, what was the price per barrel of oil in 1981?

Reviews

Write a Review

Civil Engineering Questions & Answers

  What percent increase in shear force would be experience

What percent increase in shear force would be experience on the flat sides of a 40 ft long truck trailer as the truck speed increases from 65 mph to 75 mph. Kinematic viscosity of the air is 1.6x10^4 ft^2/s.

  Calculate the average velocity of the flow leaving

Water enters a cylindrical tank through two pipes at rates of 250and 100 gal/min. If the level of water in the tank remains constant, calculate the average velocity of the flow leaving thetank through an 8-in. inside-diameter pipe.

  What maximum force can this person apply with the jack

A person of mass 80kg places all their weight on the pedal of a foot operated hydraulic jack. The diameter of the hydraulic cylinder under foot pedal is 4cm and the diameter of the jack cyclinder is 9cm (Assume g is 9.81 m/s^2)

  Determine the maximum displacement of the plate a if the

determine the maximum displacement of the plate a if the billet strikes the plate with a speed of 8 . neglect the mass

  Calculate loads on floor and roof one way slabs

The proposed 4 story reinforced concrete office building including a green roof is to be constructed. The building is confirm to IBC 2006/2009 and ACI-318-11. 1) Calculate Loads on Floor and Roof one way slabs.

  Which has the larger hydraulic radius and by what percentage

Two pipes, one circular and one square, have the same cross-sectional area. Which has the larger hydraulic radius, and by what percentage

  Write expression for engineering strain associated with a

A piece of wire is stretched from length l1 to length l2 (step A), and then from length l2 to length l3 (step B). (i) Write down an expression for the engineering strain associated with step A.

  Calculate the elastic recovery

A 10-mm diameter bar of 1040 carbon steel is subjected to a tensile load of 50,000 N, taking it beyond its yield point. Calculate the elastic recovery (or strain) that would occur upon removal of the tensile load.

  What should be the length of an aluminum wire of 6 mm

What should be the length of an aluminum wire of 6 mm in diameter so it can be twisted one full turn without exceeding a shear stress of 42 MPa G = 27 GPa.

  Determine the room temperature when the student comes back

A NCSU student turned on his/her 150 W fan inside his/her room, 4m * 6m * 6m, before going to class in the morning of a summer day, excepting to find his/her room cooler when he/she returns at night.

  Determine mechanical properties of ametal by concucting test

if you were asked to determine the mechanical properties of ametal by concucting a test, what type of test whould you use, and what data can you abtain from that test

  Shown in the figure are a mast and a portion of the rigging

shown in the figure are a mast and a portion of the rigging of a schooner. members cd and ef lie in the same plane.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd