Find the output voltage produced

Assignment Help Electrical Engineering
Reference no: EM13701023

A 6-bit DAC has an input of 1001012 and uses a 10.0-V reference. a. Find the output voltage produced. b. Specify the conversion resolution.

Reference no: EM13701023

Questions Cloud

Where are the respective reference points of particles : Two particles A and B start from rest at the origin s=0 and move along a straight line such that a_A=(6t - 3) ft/s^2 and a_B=(12t^2 - 8) ft/s^2, where t is in seconds. Where are the respective reference points of particles A and B? What are the direc..
Using constant specific heats at room temperature : A closed gas turbine unit uses neon as the working fluid. There are two stages of compression with inter cooling from 480kPa and 290K to a maximum pressure of 2.75MPa with an intermediate pressure of 1149kPa. The regenerator has an effectiveness of 6..
For an adiabatic in viscid flow : For an adiabatic in viscid flow, write the entropy equation in general coordinate-independent form and in Cartesian coordinates. What does the equation express? Can we say that entropy is constant in an entire such flow (explain your answer)?
What range of input voltages would produce : An 8-bit ADC with a 10.0-V reference has an input of 3.797 V. Find the digital out- put word. What range of input voltages would produce this same output? Suppose the output of the ADC is 101101112. What is the input voltage?
Find the output voltage produced : A 6-bit DAC has an input of 1001012 and uses a 10.0-V reference. a. Find the output voltage produced. b. Specify the conversion resolution.
The volume flow rate at the exit of the pipe : Carbon-dioxide gas at 3MPa and 500 K flows steadily in a pipe at a rate of 0.4kmol/s. Determine a) the volume and mass flow rates and the density of carbon dioxide at this state. If CO2 is cooled at a constant pressure as it flows in the pipe so that..
A rich benefactor calls a meeting with two deans : A rich benefactor calls a meeting with two Deans. The benefactor wishes to make a $100 donation to the two schools, but requires the deans to engage in the following bargaining game to divide the money. First the Dean L offers the Dean R a porti..
What maximum shear stress is experienced by other surface : A cylinder is internally pressurized to a pressure of 100 MPa. This cause tangential and axial stress in the outer surface of 400 and 200 MPa respectively. Make a mohr circle representing of the stress in the outer surface. What maximum shear stress ..
Significant event relate to the changes on health care : How does this significant event relate to the changes on health care and in your opinion, has this event impacted the historical evolution of health care? If so, how? If not, could it?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine capacitance of the sphere without the coating

A conducting sphere in free space has a radius of a= 10cm. the capacitance of the isolated sphere is C= 4oa. now let's coat the sphere with a dielectric with fr= 3, and the thickness of the dielectric layer is d.

  Determine what is the time constant of the series rc circuit

A voltage of 20 u(t) V, where u(t) is the unit step function, is applied to a circuit consisting of the series combination of a 100 KΩ resistor and a 0.01 μFCapacitor. a.) What is the time constant of the series RC circuit

  Determine the power of the modulated signal

An angle-modulated signal with carrier frequency ???ωc=2πx106 is described by the equation φEM(t) =10cos(ωct +0.1sin200πt) (a) find the power of the modulated signal. (b) find the frequency deviation Δf. (c) find the phase deviation ΔΦ.

  Find values of resistance-voltage and current for total

find values of resistance, voltage, and current for total and all 3 voltage drops where only certain information is given out of three voltage drops info given total voltage is 12v, resistance 1 is 2.2KO, resistance 2 is 1.6KO, and resistance 3 is..

  Obtain an corresponding iir digital high passs filter

The normalized lowpass filter with a cutoff frequency of 1 rad/sec is given as Hp(s) 1/s+1 a. Use Hp(s) and the BLT to obtain an corresponding IIR digital high passs filter with a cutoff of 30 Hz, assuming a sampling rate of 200 hz,

  Plot the current waveforms on both sides of the converter

A switch-mode dc-dc converter is operating at a switching frequency of 20kHz, and Vd=150V. The average current being drawn by the dc motor is 8.0 A. In the equivalent circuit of the dc motor, Ea=100V, Ra=0.25 ohm, and La=4mH.

  Determine the electric field strength on the z axis

A radially dependent surface charge is distributed on an infinite flat sheet in the x-y plane and is characterized in cylindrical coordinates by surface density ps = p0/p, where p0 is a constant. Determine the electric field strength, E, everywher..

  Find the fundamental period of the signals are periodic

find the fundamental period. x(t)= summation of k=-5 and 5 w(t-2k) for w(t) depicted in figure. the figure is graph from negative 1 to infinite and postive 1to infinite on x-axis, a straight line connecting the negative 1 and 1 on the x-axis to p..

  What value of r will result in a critically damped response

The resistance, inductance, and capacitance in a parallel RLC circuit are 2000 Ohms, 250 mH, and 10 nF, respectively. a) calculate the roots of the characteristic equation that describe the voltage response of the circuit.b) Will the response be over..

  Find the closed-loop transfer function of the dc motor

For an armature-control DC motor the following parameters are given: ea=22V, f=5x10^-3 onz-in/rad/sec, J=4.27X10^-4 in-onz-sec^2, La=0, Ts=10 onz-in (stall torque), wo= 480 rad/sec (no load speed), K=7.66 in-onz/amp.

  Determine what is the actual maximum channel capacity

Given the narrow audio bandwidth of a telephone transmission facility, a nominal SNR of 56DB and a distortion level of

  Calculate the position of the fermi level

Boron donor atome at a concentration of 10^15 cm^-3 are distributed uniformley throughout a silicon sample. The sample is then also doped with 6*10^15 cm^-3 of phosphorous. calculate the position of the Fermi level

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd