Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
We are testing a single sideband system using a two-tone signal. The frequencies Of the signal are 600 Hz and 1.6 kHz with the carrier at 90 kHz. If the rms voltage levels for the 2-tones is 3.22 volts and the load resistor is 71 Ohms, find the output frequency spectrum, PEP, and the average power output.
A 1.2 MW wind turbine has a rotor diameter of 64 m. the turbine operates in an area with an average wind velocity of 7.5 m/s and the air density of 1.18 kg/m^3. the turbine power coefficient including the unit efficiency is 42.8 percent.
Determine the ROM size and contents to implement a function which converts a sign and magnitude number from -5 to +6 to two's complement format.
a). Determine the power this amplifier will deliver to a 4 ohm load, to an 8-ohm load, and to a 1K-ohm load b). What would be the open-circuitvoltage of the amplifier if the signal level were increased
a. Sketch the spectrum of the sampled signal up to 20 KHz. b. Sketch the recovered analog signal if an ideal (brick wall) low pass filter with a cutoff frequency of 4 KHz is used to filter the sampled signal in order to recover the orig..
A wafer 100mm in diameter is mounted in an electron-beam evaporation system in which the spherical radius is 40cm. Use Eq. 6.7 to estimate the worst-case varation in film thickness between the center and edges
How does noise affect the measurement signals in analog and digital data lines. Why is one signal sensitive to noise and the other one is not
A CMOS output driver circuit on an IC is connected to an external transmission line. The NMOS and PMOS transistors have gate oxide thickness d = 2.0 nm and channel length L = 0.25 mum. The power rail is VDO = 1.0 V.
A 230V, 25hp, shunt DC motor draws an armature current of 90Aat full rated load. The armature resistance is 0.2 ohms and theshunt field resistance is 216 ohms. Determine the rotational lossesand motor efficiency at full load.
Consider an oxide-to-n-type silicon junction at room temperature. The impurity doping concentration in the silicon is Nd=8 x 1015 cm-3. Calculate the maximum space charge width in the silicon.
Select f and K so that the steady-state error to a ramp input is less than or equal to 25% of the input magnitude.Determine the percent overshoot for a step input for the design selected in part (b).Use MATLAB to plot y(t) for a step input R(s).
Write the formula for the magnetization volume current density J M and magnetization surface current density JMS in terms of magnetization vector M. 4. A sphere has permanent magnetization where is a positive constant.
Determine the probability that the receiver correctly receives the codeword for the first time on the k-th transmission. Also determine the average number of transmissions until the receiver correctly receives the codeword.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd