Find the numeric solution to the conduction angle equation

Assignment Help Electrical Engineering
Reference no: EM13273947

Use a Spread Sheet or MATLAB or write a computer program to find the numeric solution to the conduction angle equation for a 60hz Half-Wave rectifier circuit that uses a filter capacitance of 100,000µf. The circuit is designed to provide 5v and 5a. Solve

[(Vp-Von)exp(-t/RC)= Vp Cos wt - Von ]

 

Reference no: EM13273947

Questions Cloud

Determine the capacitance values for each case : Simulate the second-order RLC circuit using simpower Matlab simulink.This circuit has DC source voltage Vs=220V, Inductance L=2mH and Resistance R=160 ohms.Determine the capacitance values for each case
What was its interest expense : Molteni Motors Inc. recently reported $3.25 million of net income. Its EBIT was $7.25 million, and its tax rate was 35%. What was its interest expense? Round your answer to the nearest dollar. Enter your answer in dollars.
Calculate the assembly energy for the configuration : Four equal point charges Q form a square of side length a. Calculate the assembly energy for this configuration.
Discuss the relevance and reliability : Discuss the relevance and reliability of estimates used in managerial accounting versus the relevance and reliability of historical information that is used in financial accounting.
Find the numeric solution to the conduction angle equation : Use a Spread Sheet or MATLAB or write a computer program to find the numeric solution to the conduction angle equation for a 60hz Half-Wave rectifier circuit that uses a filter capacitance of 100,000µf. The circuit is designed to provide 5v and 5a..
Determine the angular speed of disk : A disk 8.00 cm in radius rotates at a constant rate of 1,200 rev/min about its central axis. Determine its angular speed in radians/sec
Explain equilibrium concentration of phenanthrene : Predict the aqueous phase equilibrium concentration of phenanthrene at 25*C if the values for this compound are Cs = 1.1 mg/L, P^v = 1.6 x 10^-7 atm, KH = 4.0 x 10^-5 atm*m^3/mol, and logKow = 4.52.
Estimate the total charge enclosed within the cube : a)apply gauss's law to find the total flux leaving the closed surface of the cube. b)evaluate - *D at v the center of the cube. c)estimate the total charge enclosed within the cube.
Compute the wavelength of each of the lines : Hydrogen atoms are excited by a laser to the n=4 state and then allowed to emit. What is the maximum number of distinct spectral lines (lines of different wavelengths) that can be observed from this system? Calculate the wavelength of each of thes..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Define j-k flip flop circuit design

This solution shows how to work from a given circuit implementation (a J-K flip flop circuit design) to derive the Boolean Logic and in so doing so simplify such logic using Boolean Algebra rules

  What is the per-phase current

A three-phase substation transformer operating at 34.5kV is loaded to 24 MVA. What is the per-phase current? (assume balanced conditions)

  Calculate the turbine work per unit mass at the throttle

Consider a regenerative Rankine cycle with a 600_C and 4-MPa throttle, a 5-kPa condenser, and an open feedwater heater at 500 kPa. Turbine efficiencies are 85%. Neglect pump work. (a) Draw labeled, coordinated T-s and flow diagrams.

  Design an iir high-pass filter using bilinear method

design an IIR high-pass filter using bilinear method in a system with sampling frequency of 100 Hz. The lower and higher cutoff frequencies are at 18 Hz and 35 Hz respectively. Pre-warp the cutoff frequencies.

  Find max thermoelectric generation efficiency for any temp

A newly proposed thermoelectric generation material is the skutterudite family, such as FeAs3 or CoAs3. Assuming this new material has a Seebeck coefficient S = 35 V/K (microvolts per degree Kelvin), the electronic conductivity =1x104 (Ohm-cm)-1

  Determine what is the frequency response of the system

The unit step response of a linear time invariant system is s(t) = (1 - e-at)u(t). Where "a" is a positive, real valued constant. What is the impulse response of the system. What is the frequency response of the system.

  Find the force on a particle carrying positive charge

A positive charge of 625 nC is uniformly distributed around a circular ring of radius 3 m that is positioned in the x-y plane. The center of the circle is at the origin. The relative permittivity of the medium is Epsilon_r = 1.

  What will the pressure be if the temperature is raised

A rigid container holds hydrogen gas at a pressure of 3.0 atm and a temperature of 2.0° C. What will the pressure be if the temperature is raised to 10° C

  Calculate the triggering angle for the speed of 1000rpm

A 220 V, 1500 rpm, 11.6 A (armature current) separately excited motor is controlled by a single phase, full wave SCR converter. The armature resistance of the motor is 2 ohm. The ac source voltage is 230 V (rms) 60 Hz.

  Using sr flip-flops and nand gates design a system

Using SR Flip-flops and NAND gates, design a system that outputs 1 if it takes an even number of clock cycles to recognize the pattern 11-0-101. Otherwise it outputs 0.

  Find percentage increase in available current for starting

A standard 12-V car battery has an ampere-hour rating of of 30 Ah, whereas a heavy-duty battery has a rating of 51 Ah.  the ratio of available energy is 1.7 ratio.  Find the percentage increase in available current for starting

  Find values of external resistors for astable multivibrator

determine the values of the external resistors for a 555 timer used as an astable multivibrator with an output frequency of 2 kHz, if the external capacitor C is 3.0 mf and the duty cycle is to be approximately 75%

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd