Find the number of poles in the machine and generator

Assignment Help Electrical Engineering
Reference no: EM13253774

A three phase motor is connected to a 60Hz electrical source. The motor spins at 600rpm. Find the number of poles in the machine. The output of the above motor is connected to the input of a generator. The generator has 10 poles. Determine the electrical frequency of the generator input.

Reference no: EM13253774

Questions Cloud

Find the input power to the generator in horsepower nd watts : A 500-kVA, 60Hz, 5000V, Y-connected, 10 pole synchronous has internal parameters of Armature Resistance 1ohm amd Synchronous Reactance 10ohms. The generator is operating at rated values and 0.9 pf leading.
What is the total charge on the solid cylinder : A solid insulating cylinder of radius A is surrounded by a hollow, concentric conducting cylinder of inner radius A and outer radius B. What is the total charge on the solid cylinder
Determine the induced internal voltage and torque angle : The input power to the geenrator is 100hp. When the generator is operating at rated values and unity power factor, the generator is 80% efficient. a.) Find the generator speed in rpm and rad/sec. b.) Find the mechanical torque supplied to the gener..
What is the maximum possible power that generator can supply : A three-phase, 5kVA, 208 V, four-pole, 60Hz, Y-connected synchronous generator has negligible stator winding resistance and a synchronous reactance of 8 ohms per phase at rated terminal voltage.
Find the number of poles in the machine and generator : A three phase motor is connected to a 60Hz electrical source. The motor spins at 600rpm. Find the number of poles in the machine. The output of the above motor is connected to the input of a generator.
Statement of problem or problems facing the firm : Statement of problem or problems facing the firm. State the problem(s) clearly andsuccinctly. Explain why you believe it (or they) is important.
Explain what is the internal energy change : The enthalpy change for the reaction below at 25oC is -1,850 kJ (per mole of C9H20). What is the internal energy change for the reaction at 25oC
What is the magnitude of the magnetic flux density : An infinitely long wire is placed in a space with relative permeability of 9000 carrying current of 1.9 A in the +y direction. What is the magnitude of the magnetic flux density at (0.03,0,0) [meters] in units of Tesla
What are the observable artifacts : What are the observable artifacts, espoused values, and basic assumptions associated with Cisco's culture? Explain.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Explain single phase circuit

Single Phase Circuit, A resistor and a capacitor are connected in series across a 150 V a.c supply. When the frequency is 40 Hz the current is 5 A

  What value should resistance rs inserted in the source lead

A CS amplifier using an NMOS with gm = 3.8 mA/V is found to have an overall voltage gain of -16 V/V. What value should a resistance RS inserted in the source lead have to reduce the overall voltage gain to -8 V/V

  What is the period for a signal with pwmper

A HCS12 embedded timer is in PWM mode. If the E-clock is 24 MHz, and a scaler value of 16 is selected, what is the period for a signal with PWMPER = 0x75

  Calculate the resistor values in the designs for scaling

Frequently, the output of transducers are much smaller than what an A/D converter expects on its input. That would require an amplifier to match it. Sometimes the output does not start at 0V. Usually the minimum reference input voltage of an A/D

  Develop contoller as sequential ckt using min num of d-ff

To develop contoller as a sequential circuit using minimum number of D flip-flops and the minimum number of external gates. the controller should set the values of the control lines appropriately to drive the combinational logic circuit.

  Finding peak amplitude and frequency

Finding peak amplitude, frequency, and spectrum shape, b. A signal generator outputs a unipolar square wave with a period of 0.50 ms and an amplitude of 2.0 V. The output of the generator is passed through an ideal band pass filter that has a pass..

  Determine the rate of integrator drift with vin

Design an integrator whose output voltage Vo(t) is related to the input voltage Vin(t) by Determine the rate of integrator drift with Vin = 0 if the input-offset voltage VOS is 2mV

  What is the velocity of the torpedo relative to the earth

A spaceship moves at a speed of 0.85 c away from theEarth. It shoots a star wars torpedo toward the Earth at aspeed of 0.80 c relative to the ship. What is the velocity of the torpedo relative to the Earth

  What is the value of n that could lead to the minimal delay

Consider a long wire represented as distributed RC sections. The total wire length is 5mm. To reduce the wire delay, we uniformly insert n buffers along the wire. Suppose r=12Ohms/m and c=0.2fF/m and the delay of each buffer is 1ns.

  Calculate the developed torque at full load

A 480V, 60 Hz three phase induction motor has the following parameters: R1=R' 2= .3 ohms Xeq= 1 ohm Xc=600 ohms At full load, the motor speed is 1120 rpm, the rotational loss is 400W and the core loss is 1 kW.

  How to calculate the carrier power

If an AM signal has an un-modulated carrier voltage Vc=A volts(pk) and a load resistance RL of B ohms. How to calculate the Pc (Carrier Power) If the modulation index is known as m, how to calculate the Sideband Power (Psb)

  What is the approximate slant-range resolution

A pulse compression radar transmits rectangular chirp pulses with bandwidths of 500 MHz. What is the approximate slant-range resolution after Dolph-Chebyshev frequency weighting that results in 30-dB sidelobes

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd