Find the number of binary digits n required to have ber

Assignment Help Electrical Engineering
Reference no: EM13292427

A band limited randomsignal of band width 10kHz is uniformly distributed over the range(-1,+1) VOLT, it is sampled at twice Nyquist rate and quantizedinto Q levels. The samples are binary PCM encoded into n bits whichare transmitted using two waveforms S1 (t)=1.414 sin(w1t) and S2(t)=1.414 sin(w1t) + 1.414 cos(w1t) where t is between 0 and Tb,and the a priory probability of S1 is p(s1) = 0.4. Abinary matchedfilter receiver is used and a WGN is added with No=E(-7)w/Hz.
a) Find the number of binary digits n required to have BER=E(-4)
b) find the ratio of message signal power of m(t)to the noise output due to channel error and quantization error indB.
c) Find the signal to qunatization error ratio, and signal to channelerror ratio and comment.
d) Suggest a minimum modification for the waveforms to gain some advantages for the same error probability, and specify thisadvantages. Find also the effect of this modification on the resultobtained in (b) above.

Reference no: EM13292427

Questions Cloud

Determine the yield to maturity on a bond : Using the following parameters determine the yield to maturity on a bond.
Explain what is the value of dh°rxn : A 35.6 g sample of ethanol (C2H5OH) is burned in a bomb calorimeter, according to the following reaction. If the temperature rose from 35.0 to 76.0°C and the heat capacity of the calorimeter is 23.3 kJ/°C, what is the value of DH°rxn. The molar ma..
Compute the magnitude of the initial acceleration of crate : A 66 kg crate is dragged across a floor by pulling on a rope attached to the crate and inclined 15° above the horizontal. what is the magnitude of the initial acceleration of the crate
What are the cash flows associated with the project : However, the clinic has to py the organizers of the exposition a fee for the marketing value of the opportunity. this fee, which must be paid at th end of the second year, is $2 million.
Find the number of binary digits n required to have ber : The samples are binary PCM encoded into n bits whichare transmitted using two waveforms S1 (t)=1.414 sin(w1t) and S2(t)=1.414 sin(w1t) + 1.414 cos(w1t) where t is between 0 and Tb,and the a priory probability of S1 is p(s1) = 0.4.
What is the acceleration of the girl : A 43 kg girl and an 8.4 kg sled are on the frictionless ice of a frozen lake, 17 m apart but connected by a rope of negligible mass. What is the acceleration of the girl
Find the output snr with reasonable assumptions : An FM transmission system with r.m.s frequency deviation=100kHzis used to transmit a Gaussian base band information signal havingflat spectrum to 10kHz. Through a fading channel. The transmitted power is 5watt.
What is the sociological imagination : What is the sociological imagination and why is it considered so important by many sociologists?
Define how to compute the specific rotation of the compound : An aqueous solution containing 4.95 g of an optically pure compound was diluted to 300 ml with water and placed in a polarimeter tube 20 cm long. The measured rotation was -3.01 degrees at 25 degrees Celsius. Calculate the specific rotation of the..

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Select a pulse whose magnitude spectrum is constant

A pulse is used to measure the frequency response of a system. Since we expect the frequency response to extend to 20 kHz, we want to select a pulse whose magnitude spectrum is constant within 1% out to 20 kHz.

  What is the minimum regulator input voltage

1.)An op amp requires the design equation Vout = 5Vin & 2Vref + AgVg. What is the value of Ag 2.)The voltage dropout of a voltage regulator is 1.6 V. If a 16 V output is required, what is the minimum regulator input voltage

  Show a diagram of connections as an autotransformer

A 480-120 volt, 5kVA, 2-winding transformer is to be used as an autotransformer to supply a 480-volt circuit from a 600-volt source. When tested as a 2-winding transformer at rated load, 0.8 pf lagging, its efficiency is 0.965.

  Which of frequencies represents the pre-warped frequencies

design an IIR high-pass filter using bilinear method in a system with sampling frequency of 100 Hz. The lower and higher cutoff frequencies are at 18 Hz and 35 Hz respectively. Pre-warp the cutoff frequencies.

  Construct the straight line bode plot of the gain

Construct the straight line Bode plot of the gain. Is this a low-pass, high-pass, bandpass, or bandstop function Estimate the cutoff frequency and the passband gain. Note that s = jw. This problem uses the letter T for system function.

  Calculate the power dissipated by the bulb

A battery has a short-circuit current of 20 A and an open-circuit voltage of 12 V. If the battery is connected to an electric bulb of resistance 2 ohm, calculate the power dissipated by the bulb.

  What is the probability that team c is not successful

A conservative design team C and an innovative design team I are asked to separately design a new product within a month. From past experience, we know  The probability that team I is successful is 1/2  The probability that one and exactly one team..

  What is the magnitude of the instantaneous current at 20 us

A charged 100- picoFarad capacitor has initial voltage across it of 10 V. A 100 kohm resistor is suddenly connected across the capacitor (at t=0) to discharge it. What is the magnitude of the instantaneous current at 20 usec

  Design a 3-bit incrementer-decrementer

Design a 3-bit Incrementer/decrementer use btn_west as incrementer, i.e. when pressed, count increments by 1 use btn_east as decrementer, i.e. when pressed, count decrements by 1 use btn_south as reset, i.e. when pressed the count is resetted to 0.

  How far away can the cars radar detector receiver detect

A police K-band radar is operating, with transmit power of 1000 Watts and antenna gain of 300 in linear units. The radar unit is designed to detect a target with a radar cross-section (RCS) of 6 sq. meters and its receiver can detect a signal

  Write the delay using inline assembly language

Write a C program for the 68HCS12 microcontroller to send the pattern 0x55 to byte-sized Memory Location "OUT1" and then call a delay function. The delay function should generate a delay of two milliseconds.

  Find the power crossing into a given transverse plane

a parallel plate transmission line is made up of perfect conductors of width w = .2m and d = .01m. The medium between the plates is a diaelectric of epsilon = 2.25*(epsilon not) and mu = mu not. For a uniform plane wave propagating down the line

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd