Find the normal force exerted by the plane on the block

Assignment Help Physics

Reference no: EM13528866

A block weighing 10.82 N rests on a 34° inclined plane.

(a) Find the normal force exerted by the plane on the block.

(b) Find the frictional force exerted by the plane on the block.

(d) Find the normal force and the frictional force exerted by the block on the plane.

Reference no: EM13528866

Questions Cloud

The question asks for the magnitude and direction : The question asks for the magnitude and direction at the pin Aand int the cable BC needed to support a 500-lb ball load. The boomweight AB is neglected. AB is 8ft long and angled at 35degrees. The cable BC has an angle of 22 degrees and the500-lb bal..

What is the volume of this piece of ore : An irregular piece of unknown ore weighs 7 lb in air and was found to weigh 5.6 lb in water when submerged.

Calculate the magnitude of the electric field in side : A point charge of -2.00μC is locatedin the center of a spherical cavity of radius 6.51cm inside aninsulating spherical charged solid. The charge density in the solid7.34*10^-4 C/m^3.

Find the exact current through the third resistor : A battery supplies 0.77 A to three resistors connected in parallel. What is the exact current (in A) through the third resistor

Find the normal force exerted by the plane on the block : A block weighing 10.82 N rests on a 34° inclined plane. Find the normal force exerted by the plane on the block

Find the centripetal acceleration of the tip of second hand : The speed of the tip of the minute hand on a town clock is 0.00125 m/s. find the centripetal acceleration of the tip of the second hand

Find the change in diameter under load answer in mm : A cylinder of rock with a Poisson's ratio of 0.422 has ano-load length equal to 17.6 cm and a no-load diameter of 6.20cm. Under an axial compressive load the axial strain is foundto be -3.44 mm/m.

Find the value of the normal force : A skier of mass 65 kg skis straight down a 11° slope at constant velocity. Find the value of the normal force

Estimate the tensile strength of the wire and the work : A polycrystalline Al alloy contains a dispersion of hard particlesof diameter 10-8m and average center to center spacingof 6x10-8m measured in the slip planes. Estimatetheir contribution to the tensile yield strength,σy, of the alloy.

User Account

All Pages