Find the no-load frequency setting of the generators

Assignment Help Electrical Engineering
Reference no: EM131265519

A generating station comprises four 125 kVA, 22 kV, 0.84 pf lagging synchronous generators With a frequency drop of 5 Hz from no-load to full-load, at a frequency of 50 Hz, three generators supply a steady load of 75 MW each while the balance is shared by the fourth generator (called swing generator).

(a) For a total load of 260 MW at 50 Hz, find the no-load frequency setting of the generators.

(b) With no change in governor setting as in part (a), find the system frequency if the system load rises to 310 MW.

(c) Find the no-load frequency of the swing generator for the system frequency to be restored to 50 Hz for the load in part (b).

(d) Find the system frequency if the swing generator trips off with the load as in part (b), the governor setting remaining unchanged as in part (a).

Reference no: EM131265519

Questions Cloud

What will be the new frequency and the load sharing : In part (b) which should be the set point of G2 for the system frequency to be 50 Hz? What would be the load sharing now?
Emotionally involved in a conflict affect the situation : How would being emotionally involved in a conflict affect the situation? What are the disadvantages?
Determine its generated emf : Compute the distribution factor and coil span factor for a 3 phase winding with 4 slots per pole per phase and with coil span of 10 slot pitch.
Are there any challenges to implementing your recommendation : Is further research necessary to address the issue of Diversity and Inclusion? If so, what are your recommendations? Are there any challenges to implementing your recommendations? If so, how would you address those challenges?
Find the no-load frequency setting of the generators : Find the system frequency if the swing generator trips off with the load as in part (b), the governor setting remaining unchanged as in part (a).
Do you support the internment of your japanese neighbors : As a multi-generational American citizen, in the wake of Pearl Harbor, do you support the internment of your Japanese neighbors? As an 18-year-old male high school senior, are you eager or fearful of going to war?
Quantitative research-article summary : This assignment is aimed at giving students an opportunity to select and analyze a real quantitative (qualitative is written in the classroom) research study and explain how it may or may not be able to help improve an aspect of health care delive..
How would you interpret a correlation coefficient : ANCOVA allows us to assess the differences in group means while controlling for other variables. The reason(s) why it is useful to control for other variables is/are it and How would you interpret a correlation coefficient of -1
What consequences did the offender sustain prison time : Who committed it? How did it happen? Who was/is affected? Whose trust was violated? How much money was involved? What consequences did the offender sustain - prison time? Money repaid?

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Find the line currents and load impedance in each phase

A 3-phase , 4 wires balanced supply with BCA phase sequence is supplying the following loads connected in each phase: Phase A:20kVA at 0.8 power factor laging. Phase B:10kVA at 0.8 power factor leading.

  What is the property rights theory of the firm

What is the Property Rights Theory of the firm? Is this theory consistent with the theories of vertical integration described in Chapter 3?

  Find the current with one-v applied at room temperature

A silicon bar is 2 micro meters long and has 100 micro meters squared cross section. It is doped with 1x10^17 cm^3 arsenic. a) Find the current with 1V applied at room temperature b) How long does it take for an electron to drift from one end of the ..

  Find the current that goes through the load resistance

Two batteries with voltages in opened circuit V1 and V2 and with internal resistencies R1 and R2, respectively are connected in parallel with themselves and with a load resistance R. a) Find the current that goes through the load resistance.

  Calculate the l and c values of an l network

Calculate the L and C values of an L network that is to match a 9 ohm transistor power amplifier to a 75 ohm antenna at 122 MHZ.

  Explain why norton equivalent circuit approximates sources

A 100 V power supply has a series limmitin restor of 100 k ohms connected to its output. draw the norton equivalent cirtuit for the power supply. explain why the norton equivalent circuit you drew approximates an ideal current source

  Find an equation for the frequency of the first resonance

find an equation for the frequency of the first resonance. Suggest some methods of coupling to this resonato

  Explain what sort of waveform does the input signal have

What sort of waveform does the input signal have? Is the input signal periodic or non-periodic? If the input waveform is non-periodic, what is its pulse width?

  Social impact of cell and smart phone devices

1)Social Impact of Cell and Smart Phone Devices 2)Surgically Implanted Electronic Devices

  Determine the minimum stopband attenuation

Choose the sample at ωc equal to 0.5, and use the naive design method to compute h(n). Determine the minimum stopband attenuation.

  Explain why single inverting op amp will not work for design

Suppose we need an amplifier with input resistance of 500 kO or greater and a voltage gain of -10. The feedback resistors are to be implemented in integrated form and have values of 10 kO or less to conserve chip area.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd