Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A circular disk having a radius of 4 ft and weighing 40lb has a small weight of 20lb attached to it at a distance of 2ft from its center. If the disk is in the vertical plane and set in rotation about an axis through its center so that its minimum speed is 120 rpm, find its maximum speed.
A 220 V, 1500 rpm, 11.6 A (armature current) separately excited motor is controlled by a single phase, full wave SCR converter. The armature resistance of the motor is 2 ohm. The ac source voltage is 230 V (rms) 60 Hz.
What is the function of the enable control input of a tri-state buffer If the output of two or more tri-state buffers is connected to each other, what is the restriction on enable control input lines
A receiver has a sensitivity of 0.3 µV. The same receiver can handle a signal level of 75 mV without overloading. The receiver has a blocking dynamic range of 80 dB. If the desired signal has a level of 10 µV
Create a cron file that will regularly perform the following backups:?
If wind power at this site varies as the ratio of heights raised to the 1/7 power, compute the ratio of power in the wind that appears at the tip of the top blade relative to the power that appears at the elevation at the tip of the bottom blades.
if we have a signal source impedance that is almost as high as the input impedance of the inverting Op Amp (Rin) what effect would that have. How much signal would appear at the inverting input of the Op Amp.
What is the frequency response analysis. Which two parameters are used to determine frequency response. Draw Bode Plot for G(jw) = 10 (jw + 3) / [(jw)(jw + 2)]
A silicon diode has a doping profile such that ND = ax3. What is the depth of the junction assuming the p side is uniformly doped with NA per cubic cm. Assume the x origin is at an ideal ohmic contact on the n side of the diode.
Determine the output voltage for an op-amp comparator circuit with a non-inverting input reference voltage of + 2 VDC and an inverting input signal of - 1 VDC. The op amp reaches output saturation voltages of + or -13 V at the limits.
An input signal of 10V at 0o and a frequency of 1592 Hz is applied to a series RLC circuit with resistor R = 100 ohm, inductor L = 20 mH, and capacitor C = 250 nF. What is The value of the total circuit complex impedance.
A three-phase transmission line having a reactance of 120 ohms per phase is connected to a wye-connected load whose resistance is 160 ohms per phase. If the supply volatge is 70kV line-to-line, calculate a) The line-to-neutral voltage per phase.
Design a circuit with minimum number of gates for a binary multiplier that multiplies two unsigned four-bit numbers, Using Inverters, AND, OR gates and Full Adders.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd