Find the magnitude and location of the resultant hydrostatic

Reference no: EM13565002

1.A circular hatch is located in a sloping wall of a water-storage reservoir, where the wall slopes at ? = 35° to the horizontal, the radius of the hatch R is 840 mm, and the center of the hatch yC is 3 m below the water surface (measured along the sloping wall). Find the magnitude and location of the resultant hydrostatic forces on the hatch.

2.A 3000-lb car has a maximum speed (at sea level and on a level, paved surface) of 140 mi/h with 16-inch–radius wheels, a gear reduction of 3.5 to 1, and a drivetrain efficiency of 92%. It is known that at the car’s top speed the engine is producing 220 ft-lb of torque. If the car’s frontal area is 25 ft 2 , what is its drag coefficient?

Reference no: EM13565002

Questions Cloud

Find the resulting stress in the steel pipe material if the : If a manometer was used to measure the pressure drop and the fluid in the manometer was an oil with a specific gravity of 0.84, what would the vertical displacement of the oil menisci be for 1 inch of water pressure difference?

Find the dry unit weight of the sample : A soil has a total density of 1.80 Mg/m3. When fully dry, the soil has a density of 1.59 Mg/m3. The specific gravity of the solids is 2.57. Find the following soil parameters:

Determine the maximum acceleration of the camera : A camera is packed in a box and surrounded by packing material. The box is dropped vertically onto a horizontal surface. The vertical velocity of the box at the time that it hits the surface is v= 5m/s.

Show that the car must have exceeded the speed limit of 55 : highway patrol officer, you are patricipating in a speed trap. A car passes your patrol car which you clock at 55 mph. One and a half minutes later, your partner in another patrol car situated two miles away from you

Find the magnitude and location of the resultant hydrostatic : A circular hatch is located in a sloping wall of a water-storage reservoir, where the wall slopes at ? = 35° to the horizontal, the radius of the hatch R is 840 mm, and the center of the hatch yC is 3 m below the water surface (measured along the slo..

How many inch diameter rivets are required to transmit : How many 3?4-inch diameter rivets are required to transmit 55,000 lb from the two angles to the gusset plate if the allowable shear stress in the rivets is 15,000 psi? Assume each rivet carries the same amount of load.

Determine the shear stress in the water : Would it be more efficient to use the method of section on the diagonal cross member part of the truss or do you have to use the method of joints to determine other forces first?

Determine inside volume of the pressure : A cylindrical pressure tank has internal dimensions of 14.0 inches diameter, and 36 inches length from end to end. Max. recommended pressure at 70degF is 200 PSI. The cylinder has a safety relief valve which is set at 250 PSI.

How many gallons of water are contained in the tank if the : A spherical water tank is 10 ft in diameter. Develop a table that shows: 1) How many gallons of water are contained in the tank if the volume is measured in increments of 1 ft from the bottom to the top. 2) The mass of water at each increment, expres..

User Account

All Pages