Find the magnetic field and inductance

Assignment Help Electrical Engineering
Reference no: EM13227763

A 1000 turns wire are tighly wound on a toroid with a rectangular cross section, the heigh of toroid is 0.5 cm . The inner and outer radii of 2 cm and 3cm respectively. The current in the wire I=100 mA, Ur = 4000. N= 1000, Find H,B,phi and inductance.

Reference no: EM13227763

Questions Cloud

Explain what is the concentration of h3o in the urine sample : The electrode of a pH meter is placed in a sample of urine and a reading of 7.9 is obtained. Is the sample acidic basic, or neutral? What is the concentration of H3O+ in the urine sample?
Key aspects of the firms environment : Stage one-the analysis that includes systematic identification and consideration of the key aspects of the firm's environment and stage two-the synthesis of the key aspects into an understanding of the strategic opportunities and threats..
Calculate the unit length capacitance of the cable : The cylindrical coaxial cable with the cross section shown below, has inner and outer radii of 5mm and 15mm respectively. The dielectric parameters are; er=2, signma=5*10^(-10) S/m and Ur=1.
Explain what is the ka of hy : A 0.00445 mol sample of a weak acid, HY, is dissolved in enough water to form 0.0976 L of solution. If the pH of the solution is 4.02, what is the Ka of HY? Use E notation with 3 significant figures.
Find the magnetic field and inductance : A 1000 turns wire are tighly wound on a toroid with a rectangular cross section, the heigh of toroid is 0.5 cm . The inner and outer radii of 2 cm and 3cm respectively. The current in the wire I=100 mA, Ur = 4000. N= 1000, Find H,B,phi and inducta..
What are the maximum and minimum cycle times : The line will operate for 480 minutes per day. a. What are the maximum and minimum cycle times? b. What output rate will be achieved by each of those cycle times?
Explain the solubility of common compounds in water : Experimentally observed facts have led to the establishment of rules used to predict the solubility of common compounds in water. The rules can be stated as follows: Compounds that contain , , , and are always soluble with no particular exceptions..
What is the instantaneous frequency of the fm signal : A hybrid communication system uses both AMSC and FM. The information signal a(t) is first AMSC modulated with the subcarrier frequency 1000 Hz. Then it passes through an FM modulator with the carrier frequency 10Mhz.
What is the assembly line efficiency : What is the assembly line efficiency? (c) Is your assembly line balance solution good or bad? What criteria do you used to make this assessment? Explain.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Design an integral controller

Improve the controller designed in part by introducing a mechanism for the disturbance compensation at the plant input. Illustrate advantage of the improved controller by applying the fast varying piecewise constant reference input vector and sinu..

  Calculate the internal resistance

the output voltage of battery drop from 6V .With no load to 5.2V with a load current of 400mA. calculate the internal resistance.

  Calculate the natural frequency of oscillation

The bellows, diaphragm, and Bourdon tube pressure sensors all exhibit second order time response. This means that a sudden change in pressure will cause an oscillation in the displacement and, therefore in the sensor output.

  Examine of link budget dth qpsk satellite link

Analysis of link budget DTH QPSK Satellite link, A direct-to-home satellite television system uses a geostationary satellite in orbit above the equator at a longitude of 109 degrees west.

  Calculate the added inductance that leads to a conduction

Assume that an additional inductance can be inserted in series with the load. also assume that the converter has no freewheeling diodes. Calculate the added inductance that leads to a conduction period of 180 degrees when alpha = 30 degrees.

  How the uart can be used to fill an instruction ram

Instead of recreating the design every time we change the instruction ROM, we want to have a way to change the instructions while the system is running. Discuss how the UART can be used to fill an instruction RAM instead

  What is the signal-to-noise ratio of the spread signal

Suppose that a voice signal normally occupies 30 kHz of bandwidth and has a signal-to-noise ratio of 20 dB. Spread-spectrum techniques are used to increase its bandwidth to 2 MHz. (a) What is the signal-to-noise ratio of the spread signal

  What is the range of the sensor voltage outputs initially

a. What is the range of the sensor voltage outputs initially and finally? b. What range of voltages would be expected to be measured 2 sec after the step change is applied?

  Explain flet-compound generator has a shunt field

Each pole of a 100kW, 250v flet-compound generator has a shunt field of 2000 turns and a series field of 7 turns. If the total shunt field resistance is 100 ohms

  Explain how to design the power supply

You are working with a design team on a new product and are assigned to design the power supply. The requirements for the power supply are as follows: Input AC: 115 V AC +- 10%, 50-60 Hz Outputs: +5 V DC at 100 ma, +-12 V DC at 50 ma

  Estimate the ratio of powers generated by the same speed

Suppose a turbine is used for generating electricity, estimate the ratio of powers generated by the same speed water and air. (Water density=1g/cm3, air density =1.2kg/m3)

  Compare number of transmission paths in hybrid topologies

A star-bus hybrid topology consists of a main three branch star toplogy with each branch connecting three stations in a bus topology. This toplogy is changed to a new bus-ring hybrid topology with main five station bus topology.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd