Find the leakage current through a polyester capacitor

Assignment Help Electrical Engineering
Reference no: EM13272406

A Polyester capacitor with a leakage specification of 5x109 O -µ F is used in a circuit. The voltage across this capacitor is 100 volts D.C.and the capacitance is 0.1µ F find the leakage current.

Reference no: EM13272406

Questions Cloud

What is the rbe for the unknown radiation : Neutrons (RBE = 2.0) and some unknown radiation type have the same biologically equivalent dose. What is the RBE for the unknown radiation
Find the friction force acting between the wheel and surface : A wheel (radius 0.6 m) is rolling on a horizontal surface with a center of mass acceleration of 0.7 m/s2. find the friction force acting between the wheel and the surface
What is leakage current of aluminum electrolytic capacitor : An Aluminum electrolytic capacitor that has a capacitance of 75,000µ F,100WV is used in a power supply circuit. The leakage specification of this type of capacitors is 5µ A/µ F. If the voltage across this capacitor is 50 volts, what will be the le..
What is the least force you could exert on the fridge : Suppose that while moving into an apartment you move a refridgerator into place by sliding it across the floor. What is the least force you could exert on the fridge to move it
Find the leakage current through a polyester capacitor : A Polyester capacitor with a leakage specification of 5x109 O -µ F is used in a circuit. The voltage across this capacitor is 100 volts D.C. and the capacitance is 0.1µ F find the leakage current.
Explain which of the following is less soluble in hexane : Which of the following is less soluble in hexane, ethanol or CCl3H(l). Don't try to type the subscripts, just use letters and numbers.
Calculate the accleration on the box : A bix of mass 90 kg is sitting on the floor. The tension in the rope is 56.0N, Calculate the accleration on the box
Explain what concentration of naphthalene in grams per liter : What concentration of naphthalene in grams per liter would be needed to give an absorbance of 1.0 at 220nm
What average pewer is delieverd to circuit : A series RLC circuit has a resistance of 12 ohms and an impedance of 10 ohms, what average pewer is delieverd to circuit

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine how many atoms per unit cell does it have

Polonium (Po) is the only material which forms a simple cubic crystal (i.e., it is not FCC or BCC) structure with atoms at the corner positions. It is a metal (but it is radioactive so it has very few engineering applications!). Its atomic number ..

  What is acceleration in the direction parallel to the slope

The Schussing skier is on 25° slope. His mass is 80 Kg. The Kinetic coefficient of friction between his skis and the snow is μs = 0.08 . His velocity is 9 m/s. a) What is his acceleration in the direction parallel to the slope

  Depiction impedance diagrams

Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.

  What is the maximum amount of zinc in zinc oxide

Zinc metal can be obtained from zinc oxide (ZnO), by reaction at high temperature with carbon monoxide (CO). ZnO(s) + CO(g) Zn(s) + CO2(g)The carbon monoxide is obtained from carbon.2C(s) + O2(g) 2CO(g)

  Find the shortest impulse response

An analog signal xa(t), band-limited to 5 Hz, is sampled at a rate of 10 samples per second to give a discrete-time signal x(n) = xa(0.1n). The discrete-time signal x(n) is then filtered with an digital FIR filter, h.

  Find what is the single amount at the end of seven years

what single amount at the end of seven years is equivalent to a uniform annual series of %5000 per year for 12 years if the interest rate is 8% compounded annually

  Determine what are connected in parallel with the load

Three capacitors are found that each have an impedance of -j2.0, and they are connected in parallel with the load in a wye configuration. Determine the power factor of the combined load as seen by the source.

  What is the frequency of the current in radians per second

An 80 kHz sinusoidal voltage has zero phase angle and a maximum amplitude of 25 mV. When this voltage is applied across the terminals of a capacitor, the resulting steady state - state current has a maximum amplitude of 628.32 microamps.

  Explain what are the practical interpretations

discuss the difference(s) and similarity(ies) between the modulations index used in AM and the modulation index used in FM What are the practical interpretations

  Calculate the voltage drop across the load

A simple power system consists of a dc generator connected to a load center via a transmission line. The load power is 100kW. The transmission line is 50km copper wire of 3 cm in diameter. If the voltage at the generator terminals is 400V

  Determine the value of c in microfarads

you have a RC circuit with an unknown capacitor. You have a 20V source and a 33k ohm resistor. the question states. The voltage Vc for the network has risen to 16V 5seconds after the switch was closed. Determine the value of C in microfarads.

  What is the future worth for per year of each plan at an age

Mike and Susan hope to retire a few years early, they decided to pay closer attention to the predicted amount of retirement benefits and do some analyses on the numbers. They found that their projected benefits are substantially the same.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd