Find the horsepower added for the flow through the system

Assignment Help Civil Engineering
Reference no: EM13305928

The pump adds power to the water flowing from the lower reservoir. Find the horsepower added if the flow through the system is 400 m^3/s. The entrace is sharp, the two bends are equivalent to smooth 90 degree bends with R=1 ft, and there are two fully open gate valves ( one on each side of the pump) in the system. Reservoir one is at an elevation of 175 meters and reservoir two is at 150 meters the pip is 4 meters in diameter.

Reference no: EM13305928

Questions Cloud

Determine the frequency of vibrations : The springs of a 1100 kg car compress 4.5 mm when its 68 kg driver gets into the driver's seat. what will be the frequency of vibrations
Determine the acceleration of each plate with a force : The coefficients of static and kinetic friction are 0.3 and 0.2, respectively, between each of the plates and between plate A and the ground. Determine the acceleration of each plate.
Estimate the required volume of the aeration tank : A town is going to upgrade its primary WWTP to a secondary plant that can meet the effluent standard of 25 mg/L BOD5 and 30 mg/L suspended solids. They have selected a CSTR activated sludge system for the upgrade.
What is the specific gravity of the wood : A 0.46 kg piece of wood floats in water but is found to sink in alcohol (specific gravity = 0.79) in which it has an apparent mass of 0.037 kg
Find the horsepower added for the flow through the system : Find the horsepower added if the flow through the system is 400 m^3/s. The entrace is sharp, the two bends are equivalent to smooth 90 degree bends with R=1 ft, and there are two fully open gate valves
What is the mean velocity of air in the micro-channel : A micro-channel of diameter 0.5 mm and length 750 mm is connected to a plenum. A fan produces a negative gage pressure of -1.5 inch H2O in the plenum and draws air at 20oC into the micro- channel.
Estimate the pressure exerted on a floor : Estimate the pressure exerted on a floor by the following one pointed chair leg (56 kg on all four legs) of area = 0.06 cm2 N/m2
Determine the angular velocity of pinion gear and velocity : The pinion gear rolls on the gear racks. If B is moving to the right at 8 ft/s and C is moving to the left at 4 ft/s, determine the angular velocity of the pinion gear and velocity of its center A.
Estimate how far you will be able to focus : Let's say you have a prescription for contacts of -2 diopters. Estimate how far you will be able to focus

Reviews

Write a Review

Civil Engineering Questions & Answers

  Calculate the mass emissions rate of ash into the atmosphere

The coal has an ash content of 12% by mass. Forty percent of the ash falls out the bottom of the furnace. The rest of the ash is carried out of the furnace with the hot gases into an electrostatic precipitator (ESP).

  Find the final speed

Two carts with masses of 4.72 kg and 2.84 kg move toward each other on a frictionless track with speeds of 4.86 m/s and 3.97 m/s respectively. The carts stick together after colliding head-on. Find the final speed.

  Determine the corresponding magnitude of the bending moments

A drilling engineer wishes to support pipes of length L on blocks so that the magnitude of the bending moment in the pipes directly over the supports is equal to the magnitude of the bending moment at the center of the pipes.

  Effective vertical stresses of the clay layer

The saturated unit weight of the clay is 20kN/m 3 and that of the sand 19 kN/m 3 ; above the water table the unit weight of the sand is 16.5 kN/m 3 . Calculate the effective vertical stresses at the top and bottom of the clay layer.

  Compute the design compressive strength for lrfd

A w14X74 of A992 Steel has a length of 20 feet and fixed ends. Compute the design compressive strength for LRFD and the allowable compressive strength for ASD.

  Determine how far did the train travel during the time

A train moving at 100 km/hr decreases its speed to 80 km/hr in 3.5 seconds. How far, in meters, did the train travel during this time

  Derive an expression relating effluent concentration

Derive an expression relating effluent concentration to influent concentration, hydraulic residence time, and the reaction rate constant for a zero order reaction in a CSTR at stead-state.

  Surface overflow rate-horizontal flow through velocity

A rectangular clarifier with a length:width ratio of 3:1 receives a flow of 850m3/day. the clarifiers depth is 4.0m and the detention time of the water inthe clarifier is 2.4 hrs, what are the surface overflow rate and the horizontal flow through ..

  Determine what will go into freezing the ice

You try to freeze one liter of water at 10 degrees Celsius in ice trays in your freezer. Your freezer has a coefficient of performance of 5.5 and a power rating of 550 Watts, though only 10% of the power will go into freezing the ice.

  Find the load p and stress in the aluminum for the stress

The column is composed of two materials, the inner is brass with a diameter of 100mm and the outer is aluminum with a diameter of 150mm. A rigid flat plate is placed on top to insure that both materials move together when compressed.

  Determine what is the book value at the end of year 3

A hybrid car has a initial cost of $70,000 is to be depreciated by the straight-line method over a six years. The asset will a salvage value of $10,000. According to the straight line method, the book value at the end of year 3 is

  How much benzene can be optimally removed by the gac filter

A municipal water supply became contaminated with benzene (Cw=50g/L). It was decided that until the contaminant source could be identified and remediated, all household faucets would be fitted with a granular activated carbon(GAC) filter bed to ad..

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd