Find the guide wavelength on the line and total attenuation

Assignment Help Electrical Engineering
Reference no: EM13251356

A copper stripline transmission line is to be designed for a 592 OHMS characteristic impedance. The ground plane separation is 1.02 mm and the dielectric constant is 2.20, with tan = 0.001. At 5 GHz, find the guide wavelength on the line and the total attenuation.

Reference no: EM13251356

Questions Cloud

Draw the precedence diagram : suppose the demand rose from 750 to 800 units per day.what would you do?show any amount or calculations. g)Suppose that demand rose from 750 to 1,000 units per day.what would you do?show any amount or calculations.
Explain what is the u for the chocolate : A bomb calorimeter with an insulating heat capacity is used to burn 5.682g of a chocolate candy bar. If the 1.00kg of water in the calorimeter then increased from 18.0220C to 56.1250C, what is the U for the chocolate in kJ/g chocolate
Find an expression for the volume charge density : Find an expression for the volume charge density ?(r) inside the ball as a function of r. Express your answer in terms of the variables Q, r, R, and appropriate constants
Find the power delivered by the source in the circuit : Find the value of i1 in the circuit, using mesh-current analysis. Find the the value of i2 in the circuit, using mesh-current analysis. Find the power delivered by the source in the circuit, using mesh-current analysis.
Find the guide wavelength on the line and total attenuation : A copper stripline transmission line is to be designed for a 592 OHMS characteristic impedance. The ground plane separation is 1.02 mm and the dielectric constant is 2.20, with tan = 0.001.
Explain what thermodynamic principle does the exemplify : Calculate the standard molar enthalpy of formation of carbon dioxide from the following enthalpy changes. 2C(s) + O2(g) --> 2CO(g) [?H0 = -221.0kJ] and 2CO(g) + O2(g) --> 2CO2(g) [?H0= -566.0kJ] What thermodynamic principle does this exemplify
Find the electric field at the origin in terms of q : In the plane z=5 there is a ring with a 3cm radius with its center on the z axis. The ring has a uniformly distributed charge Q. The origin 0,0,0 is at a small sphere with a mass of 0.5kg and a charge of -Q.
How should retailers plan the process of opening : How should retailers plan the process of opening the doors and getting excited customers through checkout? What capacity planning approaches should retailers use for Black Friday?
Explain what must happen for a substance to melt : The temperature at which a substance melts or boils depends upon the strengths of the intermolecular forces. What must happen for a substance to melt in terms of particles, intermolecular forces, and energy

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Design an op-amp amplifier circuit

Design an op-amp amplifier circuit where the smallest resistor available is 10k . The circuit must yield the relationships shown in the following equation: Vout = 8v1 + 8v2 - 4va - 9vb

  What is the total impeadance of the combined three loads

Three loads are connected in parrallel across a 250 Vrms line. Load 1 absorbs 16 kW and 18 kVAR. Load 2 absorbs 10 kVA with a power factor of 0.6 leading. Load 3 absorbs 8 kW with a power factor of 1.

  Give knowledge of structure-property-processing-perfomance

Explain how to use the knowledge of Structure-Property-Processing-Perfomance relationship to improve on a device based on semiconductivity. Name the device, describe how it is made, the principle guiding its function and application.

  At which of two points in is electrostatic potential larger

A ball of radius 1 meter centered at the origin has uniformly distributed over its volume a positive charge Q. a. In moving a positive test charge from the point (x, y, z)= (2, 2, 2) to the point (4, 4, 4), do you have to do work on the test charge..

  Find the charge on the capacitor

the circuit has been connected for several seconds, find current in (a). in the 4.00 volts battery, (b). in the 3.00 ohm resistor, (c). in the 8.00 volts battery, (d). in the 3.00 volts battery and (e). find the charge on the capacitor?

  Find out the minimum signal to noise ratio

Determine the minimum signal to noise ratio (s/n) in dB required in each communication channel to achieve a data rate of 270 kbps?

  Write program to subtract 32 from fahrenheit temperature

Write a main program to call a procedure that converts the Fahrenheit temperature value stored in the location labeled TdegF to its Celsius equivalent. The range of temperatures is 32°F to 212°F. The procedure stores the converted temperature

  What fraction of the widths of the strip should be added

A 78oham lossless planar line was designed but did not meet a requirement. What fraction of the widths of the strip should be added or removed to get the characteristic impedance of 75oham

  Determine the smallest angle theta required for the man

The boards have a weight of 40 lb, centered G. Determine the smallest angle Theta required for the man to support these boards, neglecting the man's weight and the friction between his shoes and the floor.

  Write an assembly code segment that calls the subroutine

Write an assembly code segment that calls the subroutine New Function if bits 5 and 6 of PORTD equal 1. Write the same code segment in part (a) using structured assembly constructs.

  Determine the values for the period and duty cycle registers

A PWM is used in 8-bit mode to produce a signal with a 1 msec period and 60% duty cycle. Determine the value required for any pre-scaling, and the values for the period, and duty cycle registers. The E-clock is 24 MHz.

  What is the difference between series and parallel circuit

(1) What is the difference between a series and a parallel circuit (2) How do you evaluate the total resistance of a parallel circuit

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd