Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A proportional control system id to be used to control the wing flaps of a jet airplane. The wind load is expected to cause as much as 600 in*lb of torque. The system should be able to keep the flaps to within 5 degrees of the set point. Find the gain Kp necessary to meet the requirements.
The laminated silicon steel core of a transformer has a mean length of 0.06 m and a cross section of 0.005 meter square. there are 150 turns on primary winding and 450 turns on the secondary. the input is 200 V rms at 50 Hz.
Seawater with a specific weight of 64.0 lbs/ft^3 is at a level of 4 feet above the centerline of the exit pipe. The tank is closed at the top and there is a pressure of 1 psig above the seawater. What is the velocity at the end of the pipe
(a) Impulse Response of a DT LTI system is given by h[n]=(.2^n)u[n] Determine the step response of y[n] of the system for all n. (b) Given h[n]=(a^n)u[n] and x[n]=(.2^n-5)u[n-5] Evaluate y[n]=h[n]*x[n] for
A proportional controller for a rotating antenna has a gain Kp of 5 in .oz/deg. The antenna was initially pointing due south but was then commanded to point southeast. a. Find the initial torque supplied to the antenna.
A three-phase, 2000-kVA, 12-kV, 1800-rpm synchronous generator has a synchronous reactance of 20 ohms per phase and negligible armature resistance.a. The field current is adjusted to obtain the rated terminal voltage at open circuit.
If it is possible to determine whether a circuit is in resonance given only the RMS values, explain how it could be done. If it is not possible, explain what further information you would have to have.
A 100-watt motor (60% efficient) is used to raise a 100-kilogram load 5 meters into the air. If the task takes 65 seconds to complete, how heavy was the load in units of kilograms
a) What is the key difference between coherent and non-coherent demodulation b) Explain the concept of differential encoding for BPSK modulation.
Make a table showing Temperature as a function of pressure for Psat from 20 to 600 psia every 20 psi, and another table showing pressure as a function of temperature from 150 degrees to 350 degrees every 20 degrees.
A radio link has a transmitter with a power of 1 W and an initial noise of 16 mW. The receiver has a sensitivity of 125 mW and can tolerate a SNR of 15 dB. What is the maximum noise power that can be inserted
A balanced three-phase load is connected to a balanced three-phase supply via a transmission line. What must be the readings on the two wattmeters, the ammeter, and the voltmeter
A 10 K-ohm pot is used as a position sensor with a 10 -V supply. The input resistance to the interface circuit is 50 K-ohm. Find the loading error when the pot is in the middle of its range.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd