Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
A proportional control system is to be used to control the wing flaps of a jet airplane. The wind load is expected to cause as much as 600 in. · lb of torque. The system should be able to keep the flaps to within 5° of the set point. Find the gain KP necessary to meet the requirements.
A three phase transmission line has a reactance of 100 ohms per phase. The sender voltage is 100kV and the receiver voltage is also regulated to be 100kV by placing a bank of static capacitors in parallel with the receiver load of 50 MW
For a 64-PSK modulator with an input data rate(fb) equal to 36 Mbps and a carrier frequency of 100 MHz. A. Determine the minimum double-sided Nyquist bandwidth(fN) and the baud. B. Sketch the output spectrum.
The Source feed two loads, both of which areY-connected. The impedance of load 1 is 8 + j6 Ω/φ. Thecomplex power for the a-phase of load 2 is 600
computation with 5% of the code that cannot be paralleled, compute the speedup and efficiency.
Description of Transformer, An 11 kV to 415 V transformer has a rating of 100 kVA. The winding resistance and leakage reactance when referred to the secondary are 0.0142 Ohm and 0.0569 Ohm respectively
A sinusoidal voltage has a maximum value of 100V, and the value is 10V at t=0. The period is T=1ms. Determine the angular frequency, w, in rad/sec.
An ideal transformer is used for maximum power match of a 2880Ohm load to a source with a Thevenin Equivalent of 18 V and 20Ohms. (a) If the transformer primary has 140turns, how many turns are needed for the secondary
1) For a semiconductor E vs kx near the band edge Ec is given by E=Ec +(h2/16m0)*kx2. Determine the effective mass of electrons in the conduction band. Here m0 is the mass of a free electron.
The value of the capacitor from the high-voltage terminal to the tap point is 0.005µF. The tap point voltage is 4 kV. What is the value of the capacitor connected between the tap point and the ground terminal. What is the value of the tuning induc..
A) If 220kV, 220 MVA with power factor 0.8 lagging is determined to be at the receiving end, calculate the voltage at the transmitting end. B) If 220kV, 220 MVA with power factor 0.8 lagging is determined to be at the receiving end
Light traveling in air strikes a glass plate at an angle θ1 = 33 degrees, where θ1 is measured between the incoming ray and the glass surface. Upon striking the glass, part of the beam is reflected and part is refracted.
Control Systems and Laplace Transformations, What is the step response of a system whose transfer function has a zero at -1, a pole at -2 and a gain factor of 2?
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd