Find the frequencies of the poles fp1 and fp2

Assignment Help Electrical Engineering
Reference no: EM13274896

A CG amplifier is specified to have Cgs=2pF, Cgd=0.1 pF, CL=2 pF, gm=4 mA/V, Rsig = 1k-ohm, and R'L = 20 k-ohm. Neglecting the effects of ro, find the low-frequency gain vo/vsig, the frequencies of the poles fP1 and fP2, and hence an estimate of the 3-dB frequency fH.

Reference no: EM13274896

Questions Cloud

Find the 3-db frequency of the cmrr of a mosfet : A MOSFET differential amplifier such as that is biased with a current source I=200uA. The transistors have W/L=25, k'n=200uA/V^2, VA=200 V, Cgs=40 fF, Cgd=5 fF, and Cdb=5 fF. The drain resistors are 20k-ohm each.
What will be the nominal value of the spy at your retirement : The stock symbol for the ETF is SPY. If the ETF appreciates at an average rate of 4% what will be the nominal value of the SPY at your retirement age?
Explain gaseous hydrogen bromide dissolves : When a 8.26-g sample of gaseous hydrogen bromide dissolves in 36.2 g of water in a coffee-cup calorimeter the temperature rises from 25.00C to 82.14C. Calculate H in kJ/mol HBr for the solution process.
Compute the dielectric constant of the material : A parallel plate capacitor has a capacitance of 1.5 microFarad with air between the plates. What is the dielectric constant of the material
Find the frequencies of the poles fp1 and fp2 : A CG amplifier is specified to have Cgs=2pF, Cgd=0.1 pF, CL=2 pF, gm=4 mA/V, Rsig = 1k-ohm, and R'L = 20 k-ohm. Neglecting the effects of ro, find the low-frequency gain vo/vsig, the frequencies of the poles fP1 and fP2
Should the new lease be accepted : The lease cannot be broken, and the store's WACC is 12% (or 1% per month). a.Should the new lease be accepted.
Review of the topic metabolic syndrome : Discuss the biological basis of energy homeostasis, including an introduction to your chosen focus area
Calculate the npv and irr with mitigation : If the firm does invest in mitigation, the annual inflows would be $20 million. The risk adjusted WACC is 10%. a.Calculate the NPV and IRR with mitigation.
Determine what is the input capacitance of the amplifier : If the amplifier is fed from a voltage source Vsig having a resistance Rsig = 1kΩ, find the transfer funtion Vo/Vsig as a function of the complex-frequency variable s and hence the 3-dB frequency fH and the unity-gain frequency ft.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Determine the complex power drawn by each impedance

A circuit consist of two impedance,Z1=50/_45 ohms and Z2=25/_30 ohms, connected in parallel. They are supplied by a source whose voltage is V=50/_0 volts. Determined follows 1. the current drwan by each impedance

  Determine the complex exponential source

For each of the sinusoidal source functions, determine the complex exponential source that has the given source as its imaginary part. Determine the phasor representation of each of the sinusoidal source functions.

  What would be the frequency and phase for the signal

If V = 12sin( 2 pi 1800 + 45). What would you read on a DMM Would this voltage be for an inductor or capacitor What would be the frequency and phase What does the 12 stand for Explain.

  Evaluate the pros and cons of using the snr and signal

Which of these metrics are dependent on link conditions: CINR, SNR, or BER Evaluate the pros and cons of using the SNR and signal - to - interference - noise ratio ( SINR ) for estimating signal quality versus using the absolute value of the signa..

  Find the efficiency as an autotransformer delivering rated

A 5 KVA 480/120 V single phase transformer is to be used as an autotransformer to transform a 600 V source to a 480 V supply. As a single phase transformer delivering rated load at 0.8 PF Lag its efficiency.

  Calculate the number of turns of the primary winding

A distribution transformer is used to supply a household. below. The load consists of eight 100-W bulbs, a 350-W TV, and a 15-kW kitchen range. If the secondary side of the transformer has 72 turns

  What is the percentage change of the maximum torque

A 15hp (output power), 208V, three phase, six pole, y-connected induction motor has the following parameters: R1 = 0.1 ohm R'2= 0.1 ohm Xeq = 0.5 ohm A.) A fan type load is connected to the motor. The slip of the motor in this case is 2%.

  Make the resistance of the resistor equal to 10 ohms

calculate the capacitance of the capacitor and the inductance of the inductor. for the capacitor it's going to be  1/(j*2*pi*frequency*capacitance) and (j*2*pi*frequency*inductance) for the inductor but what are the valves for the capacitance and ..

  Define how energy efficiency can be traded off for bandwidth

Explain how energy efficiency can be traded off for bandwidth efficiency by multilevel modulation schemes. Rank the following modulation schemes: 64-ary PSK, Binary FSK, QPSK in terms of bandwidth efficiency and energy efficiency.

  Calculate line crurrent if the motor is operated at vac rms

consider a running motor with Z = 6 + j7 ohm A) calculate the line crurrent if the motor is operated at 120 VAC RMS B) calculate the required paralell capacitor value to reduce the line current to a minimum

  Find beta cutoff frequency of bjt and unity gain frequency

A BJT has beta =100,mod Aie=10 at 10 MHz and it is operating at a collector current of 5 mA.If transition capacitance =10pf 1) calculate beta cutoff frequency of BJT,unity gain frequency and diffusion capacitance

  Can a buck converter with synchronous rectifier operate

Can A Buck Converter with Synchronous rectifier operate in DCM at a light load. If the load is disconnected how does this affect the Inductor current.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd