Find the fourier coefficients of the input

Assignment Help Civil Engineering
Reference no: EM131299521

Design a notch RLC filter to block the third harmonic of a triangular wave.

(a) Use the results in Figure 13-4 to find the Fourier coefficients of the input for VA = 12 V and T0 = 10π ms. Design your filter with a Q of 20.

(b) Compare the magnitudes of the fundamental and of the fifth harmonic with that of the third harmonic at the input and output of the tuned filter.

2050_15fa3086-6dea-4405-8ee1-fe418c2bda13.png

Reference no: EM131299521

Questions Cloud

Identify and discuss the key steps in the closing process : Identify and discuss the key steps in the closing process that provide the most opportunity to make mistakes in processing account transactions. Why did you select these steps and what makes them confusing?
Design low-pass op amp circuit to pass only the fundamental : Design a low-pass OP AMP circuit to pass only the fundamental and the next nonzero harmonic of a 20π ms square wave. The gain of the OP AMP should be +5.
General journal for the adjusting entries : Prepare the Income Statement, Statement of Owner's Capital and Balance Sheet for Ace Lawn Care for May, 2014 - Prepare journal entries, in good form, to record the May adjusting entries. Explanations are optional. Start with Page 3 of the General ..
What is the voltage across the resistor : Very basic circuits 0.5 Amps pass through a 100-Ohm resistor. What is the voltage across the resistor? What is the law that you are using to solve this problem?
Find the fourier coefficients of the input : Compare the magnitudes of the fundamental and of the fifth harmonic with that of the third harmonic at the input and output of the tuned filter.
Find the rms value of a half-wave rectified sine wave : Use MATLAB to find the rms value of a half-wave rectified sine wave. Find the fraction of the total average power carried by the dc component plus the first three nonzero ac components in the Fourier series.
What fraction is carried by the ac components : What fraction of the total average power is carried by the dc component? What fraction is carried by the ac components?
Discuss the organisation entrepreneurial orientation : Using the case study you have constructed from the above task as a vehicle for discussion and analysis and using appropriate evaluative frameworks critically appraise and discuss the organisation's entrepreneurial orientation
Express the balance sheet data in trend percentages : Express the income statement data in common size percentages. Round percentages to two decimal places - Express the balance sheet data in trend percentages with 20X2 as the base year. Round percentages to the nearest whole number (zero decimal plac..

Reviews

Write a Review

Civil Engineering Questions & Answers

  Determine the velocity of the steam at the nozzle outlet

Helium enters an adiabatic steady-state nozzle at 200kPa and 124 degrees Celsius and 10m/s. At the nozzle exit the temperature of the helium is 100 degrees Celsius and the pressure = 150 kPa.

  What are the factors affecting thermal comfort of people\

What are the factors affecting thermal comfort of people living inside a building? Illustrate with suitable examples

  Length of contracted rectangular weir

A trapezoidal canal 6m wide at the bottom and having a side slope of 1V:2H carries water with a mean velocity of 1.0m/s to a depth of 60cm. What length of contracted rectangular weir 1.0m high should be placed at the middle of the canal to make th..

  Give one reason why this should be considered by management

A chemical plant produces a process wastewater that contains a relatively high concentration of a small number of nontoxic organic compounds, but very low concentrations of solids or salts.

  Write brief paragraph summarizing habitat simulation method

Write a brief paragraph summarizing the following Habitat Simulation Method used to analyze environmental flow requirements.

  What power is required to overcome the skin friction drag

Fluid mechanics ch.9: A supertanker has length, breath, and draught (fully loaded) dimensions of 325m, 48m, and19m, respectively. In open seas the tanker normally operates at a speed of 115 kt (1 kt=0.515m/s).

  A simply supported square timber beam is span 50m and

a simply supported square timber beam is span 5.0m and spaced 3.0m the dead load and imposed load was found to 1.5knm2

  Do any of the three wells exceed the 44 ppm level

Nitrate concentrations are often recorded in units of NO3--N/L to be compared with other nitrogen constituents. Near three rural wells nitrate concentrations were reported as 0.25 mg

  Determine the value of the horizontal thrust at the supports

The symmetrical, two-hinged arch shown in Figure S10.7has a constant second moment of area, and the arch axis is defined by the coordinates given in the table. Determine the value of the horizontal thrust at the supports.

  Determine the heights of the fluid columns for barometers

Determine the heights of the fluid columns for barometers that use the following liquids at 20 C: water, ethyl alcohol, and mercury. Why do you think mercury barometers were used in the past (before the negative health effects of mercury were know..

  Determine the peak discharge that would result no ponds

Suppose a drainage basin has an area of 288 acres with a CN=55(Runoff Coef. of 0.30). Determine the peak discharge (in cfs) that would result from a 6.0in., 24-hr assuming there are no ponds and swampy areas.

  Analysis and design of beam

A 2nd level floor system of an office block is made up of a 125 mm thick slab cast monolithically with stiff beams which are spaced L3 (centre-to-centre) as shown in Figure 1.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd