Find the force acting on the craft and maximum acceleration

Assignment Help Electrical Engineering
Reference no: EM13218402

For a "Personal water craft" water is pumped from beneath the craft and discharged out the rear in a 1.25 inch diameter stream at a velocity of 75 ft/sec. Assuming that the craft and rider weighs 650lbs find the force acting on the craft and maximum acceleration.

Reference no: EM13218402

Questions Cloud

Write the assembly instruction necessary : Given the starting address for the TC0 Interrupt is to become $5000. Write the assembly instruction necessary to place this ISR address into the interrupt vector table and then unmask the interrupt (assembly only).
What theory of profit best reflects performance of plasma : The flat-screen plasma TVs are selling extremely well. The originators of this technology are earning higher profits. What theory of profit best reflects the performance of the plasma screen makers Answer risk-bearing theory of profit dynamic equi..
Make an appropriate substitution : Use the fact that x = 2 and y = 0 at t = 0 to determine the appropriate value of the arbitrary constant in the solution set.
How to maximize happiness of administrators of the nfp : Possible goals of Not-For-Profit (NFP) enterprises include all of the following EXCEPT: maximize total costs maximize output, subject to a breakeven constraint maximize the happiness of the administrators of the NFP enterprise maximize the utility..
Find the force acting on the craft and maximum acceleration : For a "Personal water craft" water is pumped from beneath the craft and discharged out the rear in a 1.25 inch diameter stream at a velocity of 75 ft/sec. Assuming that the craft and rider weighs 650lbs find the force acting on the craft and maxim..
Show radical changes in hrm : Discuss that technological breakthrough has brought a radical changes in HRM - Cost cutting efforts have led to the decimation of unwanted layers in organizational hierarchy in recent times.
Determine the signal/noise ratio : Determine the signal/noise ratio (Eb/No) in input of the receiver for each modulation format presented below if symbol error rate (SER) is required to be 10-^4 (use the coherent detection), for the solution the appropriate graphs can be used inste..
Determine the annual worth of the costs of packing : Peyton Packing has a ham cooker that has the cost stream below. If the interest rate is 15% per year, determine the annual worth(in years 1 through 7) of the costs. year 0=$4,000, year 1=$4000, year 2=$3000, year 3=$2000, year 4=$6000, year 5=$800..
Compute the concentrations of each species at equilibrium : 25 mL of 0.100 M AgNO3 are mixed with 35 mL of 0.0500 M K2CrO4. (a) Calculate the concentrations of each species at equilibrium.

Reviews

Write a Review

Electrical Engineering Questions & Answers

  Vital information about rc series circuit

Important information about RC Series Circuit, An RC series circuit has a voltage source of 10Vac, a resistor of 10ohms, and a capacitor with an impedance of -j10ohms

  What is maximum permissible strength of electric field

how does your answer change if the bubble is elongated in the direction of the electric field and sphere and the dielectric shell are placed in an initially uniform electric field E 0 in the z direction.

  Derive a suitable sequential circuit

A sequential circuit has two inputs w 1 and w 2 , and an output, z. Derive a suitable circuit for the given condition.

  Explain binary symmetric channel

Binary symmetric channel, Assume that we are transmitting binary digits over a binary symmetric channel. Let p(x=0)=p(x=1)=0.5.

  Explain resistance of headlights

Resistance of Headlights, A 24-volt automotive battery is connected to two headlights, such that the two loads are in parallel

  Find the resistance and inductance of the circuit

an inductive circuit takes a current of 10.5 amperes when connected to a 500 volts 50c/s supply. this current rises to 12.5 amperes when frequency is reduced to 40 c/s. the voltage being maintained constant. find the resistance and inductance of t..

  Sketch the circuit schematic with flip-flops

A ripple carry adder is made of full adder cells each having 1 unit of combinational delay. To convert a four-bit ripple carry adder into a four stage pipeline adder proceed as following.

  Define pulse generator

Pulse Generator, Using one 555 timer, design a pulse generator that will have the following continuously variable ranges

  Explain the signal transmitted by a base station

The signal transmitted by a Base Station has a power of 1 mW at a distance of 1 m from the transmitter. Measurements have shown that the propagation exponent for the path loss is n=3 up to a distance of 1 km and n=4 beyond that.

  Measurements show that for a particular arrangement

Measurements show that for a particular arrangement of the equipment and at a particular amplifier setting, the system will howl if 1% of the output power is fed back to the microphone. Estimate the power gain of the P.A. amplifier in decibels.

  Why colorado should or should not shut down its coal power

How does this cost compare with the current cost of new coal figured generation at 3.5¢/kWh? Write a brief (400 words or less) argument on why Colorado should or should not shut down its coal power plants and replace them with wind farms?

  Determine the appropriate sop equations

Using this method, create and test a minority vote circuit, a circuit designed to indicate when one or no inputs are HIGH. Determine the appropriate SOP equations, enter, compile, simulate, download, and test your solution.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd