Find the force

Assignment Help Civil Engineering
Reference no: EM13210882

Two smooth circular cylinders of weight w=500N and radius r=200mm are connected at their centres by a string AB of length 600mm and rest upon a horizontal plane. Supporting them a third cylinder weight w=1000N and radius r=300mm. Find the force, S to the string AB and reaction produced on the floor at the point of contact D and E.

Reference no: EM13210882

Questions Cloud

Determine the constants sigma0 and k in the hall petch : determine the constants sigma0 and k in the Hall petch equation of 70-30 brass sample.
What are the factors affecting the hydraulic conductivity : what are the factors affecting the hydraulic conductivity?
Proponents of the antitrust view argue : Proponents of the Antitrust view argue that prices and profits in highly concentrated industries are higher than they should be. By breaking up large corporations into smaller units,
What kind of soil labs are good for the construction : What kind of soil labs are good for the construction which is underlying the wet clay is dense sand. For example, compaction, and so on.
Find the force : Two smooth circular cylinders of weight w=500N and radius r=200mm are connected at their centres by a string AB of length 600mm and rest upon a horizontal plane.
How kinematic and diffusion wave model been used : how kinematic and diffusion wave model been used for rainfall runoff modelling. main computer programme involved.
Importance of observing teaching and learning in classroom : Which of the following researchers, during the late 1880s, argued for the importance of observing teaching and learning in the classrooms for improving education?
Explain the weight percent of water in the resulting gel : PVA suspension (by weight) with 15 mL of a 3.00 % borax solution (by weight). What is the weight percent of water in the resulting gel?
Formulate and solve the minimum weight design : consider the cantilever beam-mass system. formulate and solve the minimum weight design.

Reviews

Write a Review

Civil Engineering Questions & Answers

  Well-known architect frank lloyd wright

Many years ago, well-known architect Frank Lloyd Wright designed a mile-high skyscraper, which has never been built.

  Difference between dry and moist lapse rate

Explain how the desert air can contain much more h 2 o vapor in the air than the pole, and still a lower humidity than the pole? what causes the difference between dry and moist lapse rate?

  Determining height for trajectory motion

The elastic ball bounces down a flight of rigid stairs. Determine the height h of the steps if all the trajectories between successive steps are identical. Use e = 0.85 and the initial velocity 6 m/s.neglect friction. (Theta=70 degrees)

  What is the elevation of lower point

A pre- engineering base line was run down a very steep hill.rather than measure horizontaily down hill with steel tape: surveyor measured the vertical angle with the theodolite and slope distance with 16m steel tape.

  Determine the smallest standard commercial pipe

For satisfactory operation, the static pressure at the pump inlet must not be lower than -6 m of water gage. Determine the smallest standard commercial pipe that will give the required performance.

  Calculating the force in a punch press

Calculate the force (in Kn) a punch press must exert if it is to punch out a large washer from a strip of 5-mm thick sheet steel with an ultimate shear strength of 400 MPa.

  Lifting granite rock from the bottom of lake

A 170 kg granite rock (ρ = 2700 kg/m 3 ) is dropped into a lake. A man dives in and tries to lift the rock. Determine how much force the man needs to apply to lift it from the bottom of the lake. Do you think he can do it?

  Quartzite sample in a compression testing machine

A quartzite sample in a compression testing machine is 180mm long and 54mm in diameter. what is the stress under a load of 100kN? if the modulus of elasticity is 102kN/mm2, find the strain develope in the sample.

  What is the probability that the vehicle pulling out

what is the probability that the vehicle pulling out will get in an accident with oncoming traffic?

  Importance of mineral identification in applications

What are minerals? Sketch different types of mineral crystal forms and list different types of rock forming minerals. Describe with examples the importance of mineral identification in engineering applications.

  Engineering ethics concepts and cases

Engineering ethics concepts and cases

  Determining the dry volume

A saturated sample of clay with an sl 20 has a natural water content of 32%. What would its dry volume be as a percentage of its original volume of Gs.= 2.67.

Free Assignment Quote

Assured A++ Grade

Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!

All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd