Already have an account? Get multiple benefits of using own account!
Login in your account..!
Remember me
Don't have an account? Create your account in less than a minutes,
Forgot password? how can I recover my password now!
Enter right registered email to receive password!
1.A 72-cm3 sample of moist soil weighs 141.5 g. When it is dried out in an oven, it weighs 122.7 g. The specific gravity of solids is found to be 2.66. Find the water content, void ratio, porosity, degree of saturation, and wet and dry unit weights.
2.A soil specimen has a water content of 18% and a wet until weight of 118.5 lb/ft. The specific gravity of solids is found to be 2.72. Find the dry unit weight, void ratio, and degree of saturation.
3.The area of a parking lot is calculated to be 5,474 ft^2 with an estimated standard deviation of 2 ft^2. What is the maximum anticipated error? there is a 90% chance that the error range will be what?
4.What is the concentration (M) of Al3+ in lake water with pH = 4 assuming the equilibrium below with excess Al(OH)3 (s)? The reaction is Al(OH)3 (s) --> Al3+ + 3OH-. pKsp = 32.9.
Using the DeHoff method, compute the change in internal energy when 12 liters of argon gas at 273 K and 1 atm is compressed to 6 liters with the final pressure equals to 10 atm. Assume argon behaves ideally and CV = 3/2·R.
A stockpile of gravel that has a water content of 6% is rained on so that its water content increases to 9%. Compute the difference in the weights of dry gravel in a 10 ton truckload taken from the pile before and after the rain.
determine the range from the SV to the REC in GPS; using codes C/A and P and also waves (L1 and L2). How does two of the below from the list have an effect on the codes and waves
A drop of water forms under a solid surface. assume the drop has the shape of a hemisphere just before seperating. find an expression for the diameter, D, of the droplet, in terms of the specific weight and surface tension, assuming the contact angle..
1. introductionthe groundwater level has risen and now is present in the cut. answer the following questions. show
For the case of the uniaxial compression, determine the maximum shear stresses that exist at that piont. Identify the planes on which they act by drawing the orientation of the element for these shear stresses. Show all stresses that act on the eleme..
At the design flow, it is intended to have a relative depth of 0.8. At what minimum slope can it be laid such that the velocity is at least 2 ft/s at design flow and depositied solids will be scoured out by the deisgn flow
Let us pretend you are an earthwork construction control inspector and you are checking the field compaction of a layer of soil. After compaction in the field, the density of soil was checked by excavating part of the compacted soil
Two tests are taken from the compacted mixture and checked for density. Core 1 had a density of 150 pcf and an air void content of 6.5 %. Core 2 had a density of 151 pcf. What is the air void content of core 2
In polluted areas of Texas, registered vehicles must undergo an annual emissions inspection. In Fort Bend County (near Houston), 27 vehicles failed the emissions test.
If 5 mg of NaOCl are added to one liter of water and the pH is measured to be 7.8, what is the concentration of hypochlorite ion (OCl-) in mg/L
The total gas volume that flowed through the dry gas meter was 2.785 cubic meters (at T = 60 deg F and P = 800 mm Hg). The mass of PM (particulate matter) was 1.50 g. Also, 72.0 g of H20 was collected in impingers.
Get guaranteed satisfaction & time on delivery in every assignment order you paid with us! We ensure premium quality solution document along with free turntin report!
whatsapp: +1-415-670-9521
Phone: +1-415-670-9521
Email: [email protected]
All rights reserved! Copyrights ©2019-2020 ExpertsMind IT Educational Pvt Ltd